Upload
geoffrey-webster
View
218
Download
1
Tags:
Embed Size (px)
Citation preview
PROJECT REPORTMEMB 113 : Engineering Graphic and CAETitle: Full piston assemblyGroup members:Akmal Dzaki b. Ali ME075148Armia b. Noor Rashid ME075151Mohamad Awis b. Mohamad Akip ME075161Wan Mohd Faisal b. Ab Razak ME075169Section: 01ADate: 8 April 2005Lecturer: Mr. Adzly Anuar
Description of the product
Basically the full assembly of this piston is based on a Mitsubishi car which is a Gallant. These are a few information about the piston itself:
Material: Aluminium alloyWeight: 650 gramsHeight: 220mmBore: 88mmStroke distance: 78mmCompression ratio: 10:1
This piston is designed for a low compression and a swirled type for high efficiency combustion. It can withstand high temperature because it is design for a turbo charge engine. It is made out of cast iron. In the piston head itself, there are three slots to fit the piston rings. The first two is called piston ring and the last one is called oil piston ring. All the piston rings are important but the second one is the most crucial. The reason why it is crucial is because it is the last layer of protection to prevent the engine oil to reach the combustion area. It also important to prevent the gasses due to combustion to flow downwards and into the engine block. Life span of the piston is about 200,000 to 300,000 kilometers depending on the piston rings.
Piston head
Piston ring
Oil piston ring
Piston pin
Connecting rod
Big end bearing
Cap
Screw
Nut
Full piston assembly
Explode mode