Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
CH
B-
B+
2.) Use the button on the Pro Dim 5 Remote
to choose the zone you wish to pair. Choose from
5 zones indicated by the small green light.
1.) Disconnect 110 or 220VAC power and wire your
Triac Receiver to a 110 or 220VAC triac dimmable
light and power source, as seen in the diagram above.
CH
3.) Apply 110 or 220VAC power to your Triac Receiver.
Immediately after press and hold the button
for at least five seconds. If done correctly your triac
dimmable light will flash twice and you can begin
to control your lights from the remote control.
B+
Triac Receiver
AC IN
AC OUT
NL
NL
GNDInput Voltage: 110VAC or 220VACOutput Voltage: 110VAC or 220VACMax Load: 250W@110V, 500W@220V
RoHS
WAR
NING
USE
ONLY
SOL
ID W
IRE
FOR
AC C
ONNE
CTIO
NS
Input Voltage: 110VAC or 220VAC
Triac Dimmable LightMax Load: 250W@110V, 500W@220V
Pro Dim 5Triac ReceiverPairing Instruction