PressingP PinchingP InjectingI

PPI Tools and Plant Equipment

A combination of 3 single processes: 1) Pressing/molding 2) Pinching/trimming 3) Injection molding of e.g. retainers/reinforcing ribs

This sophisticated technology is especially suitable for natural fibre interior parts such as rear package trays, door side panels, luggage covers and the like.

3 Process sTePs In one

Renewable primary materials or natural fibres used Lower overall weight of parts in comparison to other technologies Process design allows for the implementation of less tools

Technology allows for vacuum and press laminating No adhesive required due to the use of same thermoplastic basis Initial investment in production equipment significantly reduced

PPI Technology – yoUr BeneFIT

03

Tool technology Tool design including preparation of the mold flow analysis Production of prototype and series tools

Plant technology complete plant technology including injection molding units From manual up to fully-automatic feeding and removal systems complete project handling from prototype up to series

Development of components Development of natural fiber and spray cast components Production of prototypes

servIces oFFered By r+s TechnIk

We deliver single source!

Interior and exterior production lines

R+S TECHNIK GmbHAm kreuzstein 80 63477 Maintal germany

Tel: +49 6109 7123 -0 Fax: +49 6109 7123 -99

E-mail: info@rstechnik.de