Upload
nguyendat
View
215
Download
2
Embed Size (px)
Citation preview
© 2014 P&S Country Crafts LLC
www.pscountrycrafts.com
Bird House Installation Manual V. Pole Mounting Instructions (continued from previous page)
Once that is done, pre-drill 2-3 evenly spaced holes into the Wooden Bracket
leaving at least 4 inches of space at the bottom (the area of the bracket that
will be inserted into the Metal Mounting Pole).
The remaining 8 inches of the Wooden Bracket will be attached to the center
of the back of your bird house.
Drill a hole into the Metal Mounting Pole and secure the Wooden Bracket (if
you do not do this, the bird house might spin in wind). Secure the Metal
Mounting Pole into the ground using cement.
P&S Country Crafts LLC
www.pscountrycrafts.com
I. Before You Begin
Thank you for purchasing a P&S Country Crafts bird house!
This booklet will provide you with instructions on how to mount your bird
house to a tree/Wooden Post or to a Metal Mounting Pole. These are the best
mounting options for a successful bird house because it provides the
greatest protection from predators.
II. Required Items
III. Positioning & Tips
The location of your bird house is extremely important for it to function as
intended. Key recommendations include:
The entrance should face away from the tree line.
Bird houses should be 5 to 20 feet off the ground.
If using a Metal Mounting Pole, do not use a pole taller than 10 feet as
the bird house may sway during any winds. A Wooden 4 x 4 Post will
not sway in the wind.
When drilling holes, make sure the screws do not go all the way into the
bird house. This could be harmful to the birds.
Pole Mounting Items (not included)
1. 5-20 foot Wooden 4 x 4 Post
- OR -
5-10 foot Metal Mounting Pole (1-2 inches in diameter)
2. 12 inch Wooden Bracket
3. Cement
Enclosed Items
1. Bird House
2. Straight Bracket (1)
3. 1½ inch screw (2)
4. 2½ inch screw (2)
IV. Tree/Wooden Post Mounting Instructions
Using the 1½ inch screws, attach the straight bracket to the back of the bird
house (be sure to center it at the top). Then use the 2½ inch screws to attach
the Straight Bracket/bird house to a tree or Wooden 4 x 4 Post. If using a
Wooden 4 x 4 Post, secure with cement.
V. Metal Mounting Pole Instructions
Take a piece of wood (this will be your Wooden Bracket) and cut it down to
12 x 1 x 1 inches, or 12 x 1 x 2 inches, depending on the diameter of your
Metal Mounting Pole. (continued on next page)