ENGINEERED FLOORING INSTALLATION PRODUCTS | 1201 E . Lexington
Avenue, Pomona, CA 91766
Tel: 888-872-9926 (TRAXXCORP) ~ (909) 623-8032 • Fax: (909)
623-8074 | www.traxxcorp.com
Rev. 3/15
KOOL GLIDE® PRO-W / KGX-6820• Activates all KOOL GLIDE®
seam and utility tapes.• ¾-inch depth reach.• 6-lbs
Now KOOL GLIDE® Technology for Hard SurfacesNow, with the Kool
Glide® system from TRAXX, unsightly face nailing can be eliminated
and tedious board replacement is made easy. Just put the board in
place over the Kool Glide Utility Tape. Then use the Kool Glide
PRO-W to activate the tape right through the board. This system
uses patented technology to remotely activate a specially designed
tape.
It’s safe, fast, easy and strong. If you make a mistake, simply
use Kool Glide to reactivate the adhesive and redo the job as
needed — works on carpet too!
KOOL GLIDE® PRO-W Applications:STARTER / END BOARD INSTALLATION
— For many hard wood fastening jobs, face nailing starter boards or
end boards is the only answer. But face nailing is visible from the
surface and requires matching and filling. With the Kool Glide®
system, simply put the starter board or end board in place and hit
the power button. No face nailing, matching or filling!
BOARD REPLACEMENT — The trouble with conventional methods of
board replacement is that once you have the board in place, you
have to carefully remove it, apply glue to it and replace it. This
is difficult and sometimes damages the board. With Kool Glide® you
put the tape under the board. When the board fits perfectly, just
zap it and you’re done!
CERAMIC TILE — Kool Glide® with utility tape is great for
(vertical) ceramic tile applications such as base and back splash.
Remember, the adhesive on the utility tape is non-structural and
should be not be used horizontal tile surfaces like counters and
floors.
KOOL GLIDE® AdvantagesEliminates Face Nailing. Kool Glide
installation of the starter and end rows gives you a smooth,
attractive surface. No nail holes to putty. Also, it’s much easier
than face nailing on concrete.
Easy Board Replacement. Removing and gluing a perfectly
fitting
board is one of the hardest tasks in board replacement. With
Kool Glide, once the board fits, just zap it!
Easy to Use. The Kool Glide system is microprocessor-controlled
so all the operator needs to do is place the tool over the tape and
push th button.
Easy Repairs. With hardwood installation,
reactivating tape is a lot easier than pulling nails.
Safe. Kool Glide technology is low frequency and very safe to
use.
Clean. With Kool Glide, the tool and the tape never touch. No
messy glue.
Carpet Seaming. The PRO-W also doubles as a carpet seaming
tool.
Lab tests show that the bond made with KOOL GLIDE® is more than
3 times stronger than with a finish nail.
UTILITY TAPE / KGT-8000• For hardwood, tile &
composite.• 4½-in paper, no scrim.• Great for starter / end
boards.• 22-yard (66-ft) roll
Great for Starter (or End) Rows ...and Repairs!
