Embed Size (px)
Citation preview
DETAIL A
1
1
2
2
3
3
4
4
A A
B B
C C
D D
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
Steve 6/15/2010
DWG NO
1921-26-44
TITLE
1Part 2Part 6" Single Face Body - 2Part Retainer -Assembly
SIZE
CSCALE
SignComp
REV
THIS DRAWING WAS CREATED AT NO CHARGE TO ASSIST YOU IN VISUALIZING OUR PROPOSAL. THE DRAWING HEREINIS THE PROPERTY OF SIGNCOMP. PERMISSION TO COPY OR REVISE THIS DRAWING OR TO USE THIS DRAWING FORPRODUCTION IS STRICTLY PROHIBITED AND CAN ONLY BE COPIED, REVISED OR USED FOR PRODUCTION WITH THEEXPRESSED WRITTEN PERMISSION OF SIGNCOMP.
A
Parts ListNOTESDESCRIPTIONPART #ITEM
Top, Bottom and One Side1Part 6" Single Face Body19211One Side2Part 6" Single Face Body19262 2Part Retainer19443 Corner Key52104Drill 1/8" Pilot Hole, 10" - 12" on center2Part Retainer Screw529024
NOTE: PRE-CUT KITS ARE NOT PRE-DRILLED.(Holes shown in this drawing are for reference only.Drilling of pilot holes are to be done by fabricator.)
4
3
24
1
1
2
3
24
4
4
1
24
24
DETAIL A
DETAIL B
1
1
2
2
3
3
4
4
A A
B B
C C
D D
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
Steve 12/17/2009
DWG NO
1921-26
TITLE
1Part 6" Single Face Body - 2Part 6" Single FaceBody - Assembly
SIZE
CSCALE
SignComp
REV
THIS DRAWING WAS CREATED AT NO CHARGE TO ASSIST YOU IN VISUALIZING OUR PROPOSAL. THE DRAWING HEREINIS THE PROPERTY OF SIGNCOMP. PERMISSION TO COPY OR REVISE THIS DRAWING OR TO USE THIS DRAWING FORPRODUCTION IS STRICTLY PROHIBITED AND CAN ONLY BE COPIED, REVISED OR USED FOR PRODUCTION WITH THEEXPRESSED WRITTEN PERMISSION OF SIGNCOMP.
A
B
Parts ListNOTESDESCRIPTIONPART #ITEM
Top, Bottom & One Side1Part 6" Single Face Body19211One Side2P 6" Single Face Body19262 Corner Key52103 1Part 2Part 6" Single Face Body Corner Angle5981
4
Dill 5/32" Pilot HoleCorner Angle Screw521827
NOTE: PRE-CUT KITS ARE NOT PRE-DRILLED.(Holes shown in this drawing are for reference only.Drilling of pilot holes are to be done by fabricator.)
1
1
2
4
2727
27
27
2727
2727
41
27
27
1
3
27
4
1
27
27
4
3
1
27
27
