2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 1

Navigation System: Component Tests and General DiagnosticsNavigation Check - Car-Navigation System

NAVIGATION CHECK [CAR-NAVIGATION SYSTEM]

Inspection item list

GPS Information

1. Turn ignition switch to ACC or ON position.

2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem

3. Select "Navigation Check".

4. Select "GPS Information".

5. Verify the GPS information.NOTE:- The GPS reception signal is updated every 1 s.

2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 2

6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.

Vehicle Sensors

1. Turn ignition switch to ACC or ON position.

2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem

3. Select "Navigation Check".

4. Select "Vehicle Sensors".

5. Verify the sensor output condition of the sensor being input to the car-navigation unit.NOTE:- The vehicle signal is updated every 1s.

6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.

History

1. Turn ignition switch to ACC or ON position.

2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 3

2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem

3. Select "Navigation Check".

4. Select "History".

5. Verify the displayed content.

6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.

Microphone Check

1. Turn ignition switch to ACC or ON position.

2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem

3. Select "Navigation Check".

4. Select "Microphone Check".

5. Verify the microphone input condition.

6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.