P-Series presentation May 2005

N191X Power Meters and N192X Power SensorsAgilent’s P-Series power meters and power

sensors provide wide bandwidth, fast, accurate and repeatable power measurements for R&D and manufacturing What’s New?

• 30 MHz video bandwidth

• Single-shot and real time capture at 100 M-samples per second

• Zero and calibrate while still connectedto the DUT

• Peak, average and peak-to-average ratio power measurements plus automatic time measurements

New

P-Series presentation May 2005

P-Series Power Meters and SensorsKey Features

• Key Measurements: Peak, average, peak-to-average ratio, rise time, fall time, pulse width, pulse repetition interval, pulse repetition frequency, time to positive occurrence and time to negative occurrence; time-gated and free-run measurements

• Low cost of ownership: 2-year calibration cycle on N1911A and N1912A power meters

Form factor as current EPMand EPM-P Series power meters

P-Series single channel power meter: N1911AP-Series dual channel power meter: N1912A

P-Series wideband power sensor (50 MHz-18 GHz): N1921AP-Series wideband power sensor (50 MHz-40 GHz): N1922A

P-Series presentation May 2005

P-Series Power Meters and SensorsKey Features

30 MHz video bandwidth with 100 Msamples per second continuous sampling

10 ns Time

0.5 μs = 50 samplesper division

P-Series presentation May 2005

P-Series Power Meters and SensorsKey Features

Time measurements: rise time, fall time, pulse width (duration),time to positive occurrence , time to negative occurrence

P-Series presentation May 2005

P-Series Power Meters and SensorsKey Features

Internal zero and calibration within the N1921A/22A sensors - eliminates multiple connections with external calibration source

N192XA Wideband Power Sensor Block Diagram

RF Input

To wideband amplifier and 100 MHz Sampler

Voltage Reference

From CAL DAC

Zero and Cal Path Switching

Diode Detectors

P-Series presentation May 2005

P-Series Power Meters and SensorsKey Features

• Versatile connectivity with USB2.0 (Slave), LAN 100 BaseT and GPIB as standard interfaces• IVI-COM driver • Pre-defined set-ups e.g. EDGE, WCDMA, Radar (pulse) 802.11a etc.

•Trigger input and output connectors

USB LAN GPIB

P-Series presentation May 2005

Agilent Power Solutions:P-Series, EPM-P and EPM Series

Power Meters

EPM-P Series Power Meters:peak, average, peak-to-average ratio;time-gated measurements, 5 MHz video bandwidth (E4416A/17A)EPM Series Power Meters: average power measurements (E4418B/19B)

P-Series Power Meters: peak, average, peak-to-average ratio; rise time, fall time and pulse width; time-gated measurements; 30 MHz video bandwidth(N1911A/12A)