Installation Guide

Information in this document is subject to change without notice.Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.

Printed in ChinaPrinted on Recycled Paper. Copyright © 2014 Vantec Thermal Technologies. All Right Reserved. | All Registered Trademarks Belong To Their Respective Companies.

Model: UGT-MST100/MRK-MST250

Verify the package contents.1.Attach mSATA Device by inserting the mSATA card and securing the two screws to hold the mSATA card in place.

2.

1.

2. 3.

Replace cover and secure with 4 screws.3. The device is ready to be integrated into your system.4.

Installing MRK-MST250 If you are using shorter (27mm) or longer (70mm) mSATA card, please use the instructions on page 2 to adjust the card mount.

Installing UGT-MST100 If you are using shorter (27mm) or longer (70mm) mSATA card, please use the instructions on page 2 to adjust the card mount.

Attach mSATA Device by inserting the mSATA card and securing the two screws to hold the mSATA card in place.

2.

1.

2. 3.

Verify the package contents.1. 3. The device is ready to be integrated into your system.

Installation Guide

Information in this document is subject to change without notice.Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.

Printed in ChinaPrinted on Recycled Paper. Copyright © 2014 Vantec Thermal Technologies. All Right Reserved. | All Registered Trademarks Belong To Their Respective Companies.

Model: UGT-MST100/MRK-MST250

MRK-MST250/UGT-MST100 Changing screws mount for other size mSATA card (27mm or 70mm card).

Pull side wall back slightly to unlock latch holding PCB and lift the PCB out of the housing for all 4 locking latch.1.

PCB lock by latchon side wall.

Pull side wall backslightly to unlocklatch holding PCB.

Look on the back of the Printed Circuit(PCB) for the mSATA card mount (at 50mm position).2. 3. Remove the screws and washer holding the mSATA

card mount. 4.

27mm

50mm

70mm

Move the card mount to the right position that matches your mSATA card and secure back the screws and washer that holds the card mount.

5. Secure the card mount back to the correct position using the screws remove in step #3. Attach mSATA Device by inserting the mSATA card and securing the two screws to hold the mSATA card in place.6.