Upload
vantuyen
View
229
Download
0
Embed Size (px)
Citation preview
Motorola Moto G3 TeardownHere comes with detailed steps to do Motorola Moto G3 whole teardown/disassembly.
Written By: Witrigs
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 10
INTRODUCTION[video: https://www.youtube.com/watch?v=4039WGldia0]
TOOLS:Heat Gun (1)
Suction Handle (1)
Guitar Picks (1)
T4 Torx Screwdriver (1)
Tweezers (1)
Spudger (1)
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 10
Step 1 — Motorola Moto G3 Teardown
Remove back cover.
Moto G3 plastic panel can be easily removed with the fingernails.
Step 2
Remove camera&flashlight metal cover. Use tweezers to cut strong adhesives underneath.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 10
Step 3
Undo 3 screws by T4 Torx screwdriver.
Take away plastic securing part.
Step 4
Heat up the LCD screen for a while.
Then with the help of suction cup, insert guitar picks to open a gap. Slide guitar picks or plasticopening tool to cut strong adhesives.
There is LCD screen connector on the left side, so be careful to slide guitar picks.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 10
Step 5
Release LCD screen connector firstly.
Remove LCD screen.
Step 6
Undo 14 screws by T4 Torx screwdriver
Pry up motherboard assembly.
Battery flex connector is connected with motherboard, so be careful to pry the assembly up.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 10
Step 7
Release battery flex connector.
Separate motherboard assembly from back cover assembly.
Step 8
Undo 3 screws here.
Use spudger to cut adhesives and pry the SIM&SD card reader board, then remove it.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 10
Step 9
Remove front-facing camera.
Step 10
Remove rear camera.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 10
Step 11
Remove earpiece.
Step 12
Remove loudspeaker.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 8 of 10
Step 13
Here is the motherboard.
Step 14
Use spudger to cut adhesive and pry the battery up.
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 9 of 10
This document was last generated on 2018-01-01 05:52:44 PM.
Step 15
Take away headphone jack.
Step 16
Done
Motorola Moto G3 Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 10 of 10