Upload
navigator1977
View
225
Download
0
Embed Size (px)
DESCRIPTION
suit
Citation preview
User Manual Viking Combi
The Viking Combi hood is often used on suits for commercial diving and for others
that have use for a simple and flexible hood solution. The Combi hood system has a
solution which is suitable for most light diving helmets and full-face masks on the
market. A damaged hood or neckseal is replaceable without the use of any glue.
Parts included in the Combi hood solution are as follows: 111 010 001 Latex hood
111 020 001 Latex neckseal
111 030 001 Latex cover
111 130 001 Latex collar (the part glued to the suit)
073 105 300 Inner neckring (yellow)
073 182 000 Lockring (black)
076 602 500 Grey opencell insulationhood
Sealing principle Pull the neckseal (111 020 001) over the head and adjust the conical part down along the neck.
Open the neckring and place it in position around the neck.
Pull the upper part of the neckseal up through the ring and down on the outside of the ring.
Pull your head through the latex collar glued to your suit (111 130 001).
Pull the latex collar up over the outside of the neckring and neckseal and place it approx. 1 cm above the edge of the neckring.
Put on the grey opencell insulation hood.
Put on the latex hood (111 010 001). Place it on the outside of the neckring and collar. Attach the black lockring on the outside.
Finally, apply the latex cover (111 030 001) on the outside of the lockring as an extra security measure.
Trelleborg Protective Products ABJohan Kocksgatan 10, SE-231 81 Trelleborg, Sweden
Phone: +46 (0)410 510 00 Fax: +46 (0)410 518 50 E-mail: [email protected]