Upload
agustin-woodford
View
218
Download
0
Embed Size (px)
Citation preview
Maintenance & Fluids
Mixer SeminarPresented By: Rich Gochenour
Section 2 (Maintenance) Page 3
Continuous Monitoring
Check from wet appearance on gears, tire and support roller
Monitor unusual or irregular sound while mixer is operating
Section 2 Page 3
Daily Maintenance
Check oil distribution on ring gear, tire and support roller
Check auto oilier and fill• 80w90 Gear Lube or 85w140 Gear Lube
Check hydraulic fluid level in sight glass of reservoir
Section 2 Page 3
Weekly Maintenance
Grease Support Roller Bearings (4 zerks)Grease Tilt Cylinder Pins (4 zerks)Grease Tilt Pins (4 zerks)Grease Mixer Drive Reducers (2 zerks)
Bearings and Pins-high quality extreme pressure bearing grease
Section 2 Page 5
Grease Locations
Section 2 Page 3
Monthly Maintenance
File the “Monthly Inspection”Check Oil Level in the Gear ReducerReplace Hydraulic Filters
• Replace quarterly or as needed• 10 micron absolute
Section 2 Page 7
Section 2 Page 4
Section 2 Page 3
Annual Maintenance
Drain and Replace Gear Reducer Oil• Oil-API-GL-5, No.80 or 90-capacity 80 oz.
Drain and Replace Hydraulic Fluid. Replace the hydraulic filters and clean tank.• 120-140 Gallon• See list of recommended fluids.