INSTRUCTION MANUAL

For your safety, please turn off power to both the controller and drone before handling.

INSTRUCTION MANUAL1. Introduction

Contents1 Introduction

PrecautionsIncluded AccessoriesExpanded Aircraft ViewRemote Control Diagram

Remote Control Battery Installation

Charging the QuadcopterBattery and Charging Specifications

Syncing the Remote and Quadrone

Flight Control and Adjustments

TroubleshootingParts List

23456

789101112

Warning label meanings

Important notes

2. Precautions

This product should be handled carefully. It is small, but dangerous if used incorrectly. Do not use your Quadrone beyond its intended purpose. Follow safety precautions to ensure correct use.

The manufacturer and dealer are not liable for accidental damages caused by improper or unsafe use. This product is intended for users age 14 years and up.

It is recommended to seek the assistance of an experienced adult before attempting to use this product for the first time. Help from an expert is the best way to properly assemble, set up, and fly your Quadrone for the first time. Any accidental damages or dissatisfaction are not covered by warranty and cannot be returned for repair or replacement.

Do not use in forbidden areas.

Can be dangerous if not used properly. Please read manual carefully.

Fly Quadrone in safe and open areas. Do not operate with people around.Pilot is responsible for all injuries, damage, and radio interference occurred during flight.

Can cause injuries if not used properly. Please read manual carefully.

Thank you for choosing Quadrone remote control Quadcopter. Before you fly our aircraft, this manual will give you knowledge and precautions to ensure that you use it successfully and safely. Before operating, please read this manual carefully. Keep this manual for future reference.

You can fly your Quadrone indoors, or outdoors in light wind.

WARNING

CAUTION

FORBIDDEN

CAUTION

This product is suitable for indoor and outdoor use. (The wind grade should be no more than a 4 grade). Choose a place without obstacles, and keep away from crowds and pets. Don’t play near unsafe areas, for example, near a heat source, wires, or electric power sources. Keeping away from these areas will prevent damages such as collision landing, entanglement leading to fires, electric shock causing loss of lives and property.

The interior of the aircraft consists of a number of sophisticated electronic components. To prevent moisture and water vapor, avoid using in the bathroom and in wet weather conditions. By doing so, this will prevent water vapor getting into the internal body parts and the electronic components which could cause failures and unexpected accidents.

Please use parts provided in order to prevent damage to product. Do not attempt to upgrade Quadcopter or swap out parts not provided in package.

Make sure the batteries are installed according to polarity indicated in this manual. Do not mix batteries of different chemistry/spec. Take out the batteries if you are not using the product for a long time to prevent potential leakage which can damage the remote. Please dispose of depleted batteries according to local laws and ordinances. Do not dispose improperly.

Li-Polymer batteries cause higher operational risks than any other battery chemistry, please follow its usage instructions carefully. The Manufacturer and dealer assume no liability for accidental damages caused by improper use. Do not use chargers other than the factory supplied unit to avoid potential fires and explosions. Do not crush, disassem-ble, burn or reverse polarity. Prevent metallic materials from coming into contact with battery’s polarity, and never puncture batteries to avoid fire hazards. Battery charging must be done under supervision at all times. Keep out of reach of children. Stop the use or the charging of the battery if there is an unusual increase in battery temperature. Using the battery continuously may cause the battery to expand, deform, explode, and even result in fire hazards. Please dispose of depleted batteries according to local laws and ordinances. Do not dispose improperly.

R/C models are made of various forms of plastic. Plastics are very susceptible to damage and deformation due to extreme heat or cold climate. Make sure not to store the model near any source of heat such as, an oven or heater. It is best to store the model indoors, in a climate-controlled room temperature environment.

DESIGNED FOR INDOOR & OUTDOOR USE ONLY, PLEASE KEEP AWAY FROM OBSTACLES

KEEP DRY

PROPER ASSEMBLY

SAFETY NOTES FOR NI-MH BATTERIES

SAFETY NOTES FOR LI-POLYMER BATTERIES

KEEP AWAY FROM HEAT

FORBIDDEN

FORBIDDEN

FORBIDDEN

FORBIDDEN

FORBIDDEN

CAUTION

3. Included Accessories

4. Expanded Aircraft View

This product is suitable for ages 14 years and up. Guidance is recommended for first time users.

SEEK HELP FROM AN EXPERIENCED PILOT

Li Polymer Battery x1 USB Charging Cable x1Extra Protective

Circle x1Extra Blades x4

Protective Circle

Protective Bracket

Canopy

Receiver Board

Main Frame

Blade

Motor

Extra ProtectiveBrackets x2

WARNING

5. REMOTE CONTROL DIAGRAM

6. REMOTE CONTROL BATTERY INSTALLATION

Speed mode button

Power Switch

360 Flip Button

Forward/BackwardTrim

Headless Mode

Left/RightSide Flying

Trim

Left/RightTurning

Trim

Forward/BackwardLeft/Right Side Flying

Joystick

Up/DownLeft/Right Joystick

Step 1 Step 2

Step 3

Headless Mode: Press the Headless Mode button and you will hear two beeps and enter Headless Mode. No matter what direction the quadcopter faces, it will respond according to the direction pushed on the remote. (Forward on the remote will make the quadcopter fly forward.) This makes flying simpler and more convenient for beginner pilots. To exit Headless Mode, press the button and listen for a single beep to indicate you are back in Normal Mode.

Open battery cover

Close battery cover

Use 4 AAA sized batteries, installed based on polarity indicated in manual. Do not mix batteries of different chemistry/specs.

WARNING

7. CHARGING THE QUADCOPTER

8. BATTERY AND CHARGING SPECIFICATIONS

For your safety, charge the battery under adult supervision at all times.

Battery usage and charge duration reference

Connect the USB cable to the computer, the light on the USB turns on. Then, connect the other side of the USB cable to the battery, and the light on the USB turns off. When the charging is finished, the light will turn on.

Battery TypeBattery

Specifications

3.7V 300mAh

1.5V (GP 15G R6P)

Usage Duration Charge Time

About 30 Minutes

Non Rechargeable

Quadcopter Flight Time: Up to 6 minutes

Transmitter Operation Time: Up to 18 Hours

Li-po Battery

Carbon-Zinc(Non Rechargeable)

WARNING

9. SYNCING THE REMOTE AND THE QUADCOPTER

If not used for a long time, a battery can lose its charge. Please remove battery from the remote.

Warning: If left in the remote control for a long duration of time, the battery may get damaged and cause fire hazards.

Power down the remote control. If the transmitter is not being used for a long duration of time, remove the battery for storage to prevent accidental damage or waste of battery power.

Warning: If the battery plug is not pulled out, it can cause the battery to have excessive discharge and cause a risk for a fire.

Please remove the battery from the quadcopter. Only charge under the supervision of an adult.

Turn the remote back on and the Quadcopter lights will flash more rapidly. Pull the throttle stick to its lowest position. The Quadcopter lights will now stay lit and is now synced with the remote control. Your are now ready to fly your Quadcopter.

The throttle stick at its lowest point

First, turn on the remote control. Then, connect the battery plug and circuit board plug on the Quadrone. The headlights flicker right and left after turning on. The headlights will be lighting during that time; then pull the throttle stick to it’s lowest position. The light in the middle of the controller will light up. Once it is lit up you can sync the Quadcopter. Set the Quadcopter on a flat surface and turn off the remote. Note: The battery and circuit board should not be inserted backwards, and to the correct polarity.

CAUTION

For resetting the controller:Keep both sticks at the lower right corner for 4-5 seconds, LED will be flashing, it's reset when you hear the beep.

PLEASE PRACTICE FLIGHT SIMULATION BEFORE FLYING

10. FLIGHT CONTROL AND ADJUSTMENTS

Make sure the screws are all firmly tightened.Make sure the remote and the Quadrone are both fully charged.

Play in safe and spacious areas.

Only fly the Quadcopter once you are fully familiar with the controls. Read the instructions carefully. Get familiar with all the kinds of direction controls and keep practicing them until you can fly at the best of your ability.

FLIGHT ADJUSTMENT AND NOTICE FOR BEGINNERS

1. Place the Quadcopter in a clear open area and point the tail of the helicopter to you. 2. Practice operating the throttle stick (as seen below) repeat practicing “Throttle high/low”, “Flying left/right”, and “Ascending/descending”. 3. The flight simulation practice is very important, please keep practicing until your fingers move naturally.

Up

Down

Turn Left

Turn Right

Move Right

Move Left

Backward

Forward

Throttle

Forward/backward

Move left/right

Turn

CAUTION

Step 1: Throttle Control Practice

Step 2: Directional Control Practice

Step 3: Rudder Control Practice

Make sure there are no people or obstructions in the flight vicinity.

You must first practice hovering for safe flying. This is a basic flight action. (Hovering means keeping the Quadcopter in mid air in a fixed position)

Stand approximately 7 feet diagonally behind the Quadcopter.

Raise the throttle stick slowly. Move the Quadcopter in any direction, back, forward, left and right. Slowly move the levers in the opposite direction to fly back to its original position.

If the Quadcopter is off track, lower the throttle stick and land the Quadcopter. Then move your position diagonally behind the Quadcopter 7 feet and continue practicing.If the Quadcopter flies too far away from you, please land the Quadcopter and move your position to 7 feet and continue practicing.

1. Slowly raise the throttle stick.2. Move the nose of the Quadcopter to the right or left, and then slowly move the rudder stick in the opposite direction to fly back to its original position.

When the Quadcopter begins to lift-off the ground, slowly reduce the throttle to bring the Quadcopter back down. Keep practicing this action until you can control the throttle smoothly.

CAUTION

CAUTION

After you are familiar with all the actions from steps 1-3, draw a circle on the ground and practice within the circle to increase your accuracy.

You can reduce the size of the circle as you become more familiarized with the control reflexes.

After you are familiar with steps 1-4, stand on the side of the Quadcopter and continue practicing steps 1-4. Then repeat steps 1-4 by standing in front of the Quadcopter.

1. Left/Right Turning Trim: Just before the Quadcopter lifts-off, the nose might lean left/right. When rotating right, adjust the trim to left rotation. When rotating left, adjust the trim to right rotation.

2. Forward/Backward Trim:Just before the Quadcopter lifts-off, the nose may lean forward/backward. When it leans forward, adjust the trim to backward. When it leans backward, adjust the trim to forward.

3. Left/Right Side Fly Trim:Just before the Quadcopter lifts-off, the body may lean left/right. When it leans right, adjust the trim to the left side. When it leans left, adjust the trim to the right side.

Slowly raise the throttle stick, when the Quadcopter leaves the ground, you can use the trim to correct the balance of the Quadcopter until it hovers flat.

STEP 5 DIRECTION CHANGE AND HOVERING PRACTICE

STEP 4 HONING YOUR SKILLS

Forward

Backward

TRIM ADJUSTMENT

When familiar with the previous basic operations, you can start the tumbling action. To begin, press the “High Speed” button. After the “High Speed” light is on, fly it to a height of 10 feet. By pulling the direction stick all the way back, the aircraft will roll 360 degrees. If you play outside, fly it up to 20 feet. To begin rolling, click on the high-speed rolling indicator light. The aircraft can fly as high as 10 feet. The forward, backward, left, fly stick on the right can be pushed to release 360 tumbling. For outdoor flying, the aircraft can fly up to a height of 20 feet. By pushing the corresponding stick push, you can achieve a continuous roll.

The receiver light keeps flashing.

The aircraft gives no reaction.

Motor does not respond to throttle stick, receiver LED flashes.

Main rotor spins but is unable to take off.

Quadcopter vibrates strongly.

Tail still off trim after tab adjustment, or inconsistent speed duringleft/right pirouette.

Quadcopter still wanders forward after trim adjustment during hover.

Quadcopter still wanders left/right after trim adjustment during hover.

Unable to sync transmitter. Repeat the syncing process.

Reboot and repeat the syncing process.

1. Replace motor2. Tightly fasten or replace blade.

Fully charge battery.

1. Power to transmitter and receiver.2. Check transmitter and receiver voltage.3. Poor battery contact.

Quadcopter battery depleted.

1. Deformed main blades.2. Flight vehicle battery depleted.3. No horizontal point detected.

Deformed main blades.

1. Damaged tail rotors.2. Damaged tail drive motor.3. No horizontal point detected.

Gyroscope midpoint not balanced.

1. Motor off2. Blade loose

1. Turn on transmitter and ensure battery is inserted properly.2. Use fully charged batteries.3. Re-seat the battery and ensure good contact between battery contacts.

1. Replace main blades.2. Charge or replace with fully charged batteries.3. Place on flat ground, and reboot.

1. Replace main blades.2. Replace the main motor3. Place on flat ground, and reboot.

1. Replace main blades.

11. TROUBLESHOOTING

Problem Cause Solution

Stable, flexible, flight routes, Drift 3D tumbling

12. PARTS LIST

Canopy

Name

Blades

Protective Circle

Electronic Board

Main Frame

Motor

Protective Bracket

1

Quantity

4

1

1

1

4

4

1

No

2

3

4

5

6

7

AWW INDUSTRIES™ is an innovative division of DGL Group, Ltd.Other trademarks and trade names are those of their respective owners.

AWW INDUSTRIES, 195 Raritan Center Parkway, Edison, NJ 08837.Specifications, colors and contents may vary from illustrations.Conforms to safety requirements of ASTM, FCC, & CPSIA.

BATTERY WARNING:• Do no mix alkaline, standard (carbon zinc), rechargeable (nickel hydride) batteries. • Do not mix old and new batteries. • Non-rechargeable batteries should not be recharged. • Rechargeable batteries should be removed from the appliance before being charged. • Rechargeable batteries should be charged under adult supervision only. • Exhausted batteries should be removed. • The supply terminals should not be short-circuited. • Only batteries of the same or equivalent type are recommended to be used. • Batteries should be inserted with the correct polarity.

WARNING: This product may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm.

PROP 65 WARNING

Manufactured in China. Batch Ref: XXXX

Model Number: XXXX

WARNING:CHOKING HAZARD-Small parts. Not for children under 3 years.

Tested to comply with FCC standards. FOR HOME OR OFFICE USE.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference and(2) This device must accept any interference received, including interference that may cause undesired operation.