Installation instructions for child seat GDRTools required:• Wrench 10mm, 13m• Medium Screwdriver• Wire cutters• Cordless drill with 6mm

Seat retainer mounted at a suitable point

Saddle mounted on the seat holderYou can adjust the tilt of the saddle and move on to the holder.

mount footpegsInstall the footrest, if possible below the V-brake mount. If no VBrakeAlways present is mounted below the rim.

V-BrakeShin guards fitV-Brake solve threading and leg protection. The brackets must be on the inside.Then the retaining clips on the fender mount.

To the fender struts a 5mm hole drilled in the shin guards and shin guards with a cable tie fixThe cable tie Aluverstärkung always on the run to ensure a secure attachment to

o

Drilling at the bottom of the leg protection is also a 5 mm hole and the leg protection with a cable tie to theFork mount.The cable tie Aluverstärkung always on the run to ensure a secure attachment to

If the retaining clips on the fender not be secure, you can also protect the legdirectly attached to the fender.Simply remove the retaining clips and the fender and the leg holes and protect theLeg protection with cable tie mount on the fender.

When mounted on a rigid fork, the shin guards are fitted using the included mounting brackets

After the first ride all the screws again check and tighten if necessary.

Special feature of twin-tube frame with a smaller frame size.

If the saddle does not slide far enough forward, the adapter must be reduced by approximately 4.5 cm.To the adapter with a simple hacksaw cut. Subsequently, as described previously installedCut 4.5 cm