Information for Authors ACTA ELECTROTEHNICA publishes original
scientific papers of high quality and reviewed articles after the
advisement of the editorial board. The scope of the journal covers
data acquisition, electrical machines and drives, power systems,
electromechanics, instrumentation and control, signal processing
and management in electrical engineering. For publishing in ACTA
ELECTROTEHNICA, the articles will be edited in WORD for Windows,
according the following technical conditions:
Page Setup Margins: Top: 2.54 cm Bottom: 2.54 cm Inside: 1.59 cm
Outside: 1.59 cm Gutter: 1 cm Header: 1.27 cm Footer: 1.27 cm
Mirror Margins: Paper Size: A4 210297 mm Orientation: Portrait
Layout: Section Start: Continuous Headers and Footers: Different
Odd and Even Vertical Alignment: Top Fonts: Times New Roman, 10 pt,
Justified Paragraph: Line Spacing: Single Columns: 2 Equal Column
Width: Spacing: 0.95 cm Editing the papers Basically, the proposed
papers should be organized according the following model: 1.
Section I: this section will be write on one
column: Title: 24 pt, Centered, Bold, Italic; Authors: 14 pt,
Centered; Authors affiliation: 8 pt, Centered; Abstract, keywords:
9 pt, Justified, Italic;
2. Section II: wrote on 2 columns, at the dimensions previously
indicated, with 10 pt fonts. This section will be organized by the
authors according the content of the paper. This section will be
finished by references, 8 pt, Numbered.
3. Section III: this section is dedicated to short information
about the authors, and eventually a recent photo. As an example, we
propose the following variant: Ion Gheorghe POPESCU is , at Field
of interest: .. . Address: Tel., Fax., E-mail:
Normally, the papers should have even pages number, and will be
edited according the graphical aspect envisaged by the authors. The
figures should have a good resolution, necessary for the printing
process.
Sending of papers The proposed papers could be sent by e-mail to
editorial board, at the address:
[email protected]. The authors will be notified by e-mail
with operative information about the paper. After the papers
analysis and admission for publishing, the editorial board could
request some modifications for solving certain problems related to
printing.
The responsibility for the content of each paper rests solely
with their authors.
ACTA ELECTROTEHNICA ISSN 2344 5637
ISSNL 1841 3323
mailto:[email protected]
