Increasing Productivity in the Tool Room and Production

Air Bearing Die Grinder

Die regrinds held to tight tolerances.

Good Dies = Good Cans

Rounder dies last longer.

Good Dies = More Time in Bodymaker

Air bearing technology mounted on a unified piece of solid granite delivers exceptional roundness and concentricity.

Air bearings achieve the highest degree of roundness.

Pride Engineering’s Die Grinder Technology

< 0.000381mm (<0.000015 in.)

Air Pressure

Direct drive rotary achieves smooth and accurate surface with no chatter.

Pride Engineering’s Die Grinder Technology

Direct Drive Rotary Axis

Frameless torque motor. No gears, joints or chains.

Surface Finish (0.05 µm)

2

Optimized for Can Plants

Pride Engineering’s Die Grinder Technology

Ironing Dies – Redraw Dies – Pilot Dies Trimmer Blades Redraw Sleeves

Designed to maximize productivity in the tool room.

6/7 inch Jaw Chuck reduces time between dies. Just load and go.

Pride Engineering’s Die Grinder Technology

Magnetic Chuck option expands capability to some cupper tooling.

• Magnetic Chuck can be used if preferred or for other tooling.

• Offered as an assembly with and air bearing to simplify change over with 6 jaw chuck.

Pride Engineering’s Die Grinder Technology

No special programming skills required.

Pride Engineering’s Die Grinder Technology

• Easy to use operator interface with screens for each die type – just enter print parameters and press Cycle Start.

• Pride Touch feature eliminates the need to manually touch off.

Easy to maintain.

• Maintain cleanliness each day including filter paper.

• Regrind chucks as needed.

• Change filters once per year or as needed.

Pride Engineering’s Die Grinder Technology

Less space required.

Pride Engineering’s Die Grinder Technology

Better dies make better cans!

Pride Engineering’s Die Grinder Technology