Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 1 - 2/3/2020
FEATURES
• 2’, 4’ and 8’ individual units
• Fixtures can be linked together for continuous rows
• Efficacy up to 125 lm/W
• Soft diffuse direct lighting
• Textured outdoor powder coat finishes available in
white, black, and bronze
• Premium finishes also available
• Wet Location rated
• IP66
• 0-10v dimming is standard
MODEL LUMENS INPUT WATTS Lm/W
HYDROD-4-625-35K 2,500 24 105
HYDROD-4-1000-35K 4,000 36 110
HYDROD-8-625-35K 5,000 42 118
HYDROD-8-1000-35K 8,000 66 120
LUMEN PACKAGES Based on 3500K CCT. Other CCT available.
DIMENSIONS
HYDROD - - - - - -
SERIES - LENGTH - LUMENS PER FOOT - DISTRIBUTION - POWER INPUT
LOCATION - POWER INPUT TYPE - CCT (80+ CRI)
HYDROD 2=2FT 625=625 LPF SD=SatinIce Diffuse PIT=Top CNDI = Conduit 30K=3000K
4=4FT 1000=1000 LPF PIS=Side CDB05 = Cord, Black, 5’ 35K=3500K
8=8FT XXXX=Custom LPF PIE=End CDB10 = Cord, Black, 10’ 40K=4000K
CND/LINK XX=Run Length CDW05 = Cord, White, 5’ 50K=5000K
E2E/LINK XX=Run Length CDW10 = Cord, White, 10’
- - - -
- MOUNTING** - VOLTAGE - OPTIONS FINISH -
SM=Surface Mount U= 120v-277v CRI9050=Minimum 90 CRI (R9 50) PW=Powder Coat White
WM=Wall Mount MS=Motion Sensor PB=Powder Coat Black
PMW=Rigid Pendant, White (6”, 8”, 12”, 15”, 18”, 21”,27”,
30”, 36”, 42”, 48”, 54”, 60”, 66”, 72”, 84”, 96” in Size) #EM=Emergency Circuit PBR=Powder Coat Bronze
PMB=Rigid Pendant, Black (6”, 8”, 12”, 15”, 18”, 21”,27”,
30”, 36”, 42”, 48”, 54”, 60”, 66”, 72”, 84”, 96” in Size) #EMB10=10W EM Battery PO=Powder Coat Other*
RAWM= Rigid Arm Wall Mount GTD=Generator Transfer Device
SRG=Surge Protector *Factory to be supplied with
RAL# or color chip
EXAMPLE: HYDROD-4-625-SD-PIE-CDB05-35K-PB-SM-U-EMB10
ORDERING LOGIC
3.6”
4.4”
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 2 - 2/3/2020
ROW CONFIGURATIONS
Linear runs are available in 4’ increments, utilizing 8’ and 4’ sections up to 50’.
Typically, runs are constructed with as many 8’ sections as allowed, and supplemented with 4’ sections to reach the desired length. If a
different configuration is needed to meet an aesthetic requirement, please indicate this on your P.O. when placing your order.
Standard runs over 8’ are as follows:
MOUNTING LOCATIONS END TO END LINK (E2E/LINK)
Each starter fixture will be provided with (2) mounting supports.
Each additional fixture will be provided with (1) support.
MOUNTING LOCATIONS CONDUIT LINK (CND/LINK)
Each fixture will be provided with (2) mounting supports.
WIRING LOCATIONS (TOP, SIDE, BACK)
Fixtures to be wired with UL listed wet location fittings per NEC
requirements
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 3 - 2/3/2020
SM
SM=Surface Mount
WM=Wall Mount
PMW=Rigid Pendant, White (Specify Length)
PMB=Rigid Pendant, Black (Specify Length)
RAWM=Rigid Arm Wall Mount
WM
PMx
MOUNTING OPTIONS
5.0”
3.6”
0.50”
4.4”
3.6”
3.6”
4.4”
Ceiling
RAWM
4.4”
3.6”
10.” 1.6”
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 4 - 2/3/2020
Model Lumens Watts LPW Model Lumens Watts LPW
HYDROD-4-625-SD-30K 2,500 25 102 HYDROD-8-625-SD-30K 5,000 43 115
HYDROD-4-625-SD-35K 2,500 24 105 HYDROD-8-625-SD-35K 5,000 42 118
HYDROD-4-625-SD-40K 2,500 23 107 HYDROD-8-625-SD-40K 5,000 42 120
HYDROD-4-625-SD-50K 2,500 23 110 HYDROD-8-625-SD-50K 5,000 41 123
PERFORMANCE
HYDROD-X-625-SD (80+ CRI)
HYDROD-X-1000-SD (80+ CRI)
Model Lumens Watts LPW Model Lumens Watts LPW
HYDROD-4-1000-SD-30K 4000 37 107 HYDROD-8-1000-SD-30K 8000 68 117
HYDROD-4-1000-SD-35K 4000 36 110 HYDROD-8-1000-SD-35K 8000 67 120
HYDROD-4-1000-SD-40K 4000 36 112 HYDROD-8-1000-SD-40K 8000 66 122
HYDROD-4-1000-SD-50K 4000 35 115 HYDROD-8-1000-SD-50K 8000 64 125
HYDROD-4-625-SD-35K
HYDROD-4-1000-SD-35K
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 5 - 2/3/2020
FINISHES
STANDARD FINISHES
BLACK MINI TEXTURE WHITE MINI TEXTURE
Custom finishes (PO) will incur a set up fee and will add an extended lead time to your project.
PREMIUM STOCK FINISHES
NOTE: A minimal impact to lead times will apply to products specified with Premium Stock Finishes (PSF). It is not to
be assumed that these finishes are stocked in our warehouse, but rather, are readily available to us for your project.
All other custom finishes (PO) will incur a set up fee and will add an extended lead time to your project.
PSF001 (WOOD#1) PSF002 (WOOD#2) PSF003 (WOOD#3)
PSF004 (WOOD#4) PSF005 (WOOD#5) PSF006 (WOOD#6)
PSF007 (STONE #1) PSF008 (STONE #2) PSF009 (METAL #1)
BRONZE SPARKLE TEXTURE
© 2019 StarTek Lighting America. All rights reserved. The information in this document is subject to change without notice.
1960 Swanson Ct, Unit C, Gurnee, IL 60031 • (877) STARTEK • [email protected] • www.starteklightingamerica.com
Hydro Beam Direct
Type:
Project:
Page 6 - 2/3/2020
Housing
Nominal 3 5/8” x 4 13/32” , 0.090 thick aluminum
housing
Color Colors for the housing are available in a powder coat-
ed white, black and bronze. Consult factory for cus-
tom colors.
Luminaire Length 4' or 8' lengths are available for a single stand-alone
section. Using contractor provided conduit, 4’ and 8’
sections can be joined to form longer rows up to 50’.
Lensing 1/8 Thick Impact resistant outdoor (F1) rated polycar-
bonate Lensing.
Source
Variable lumen packages are available in four
color temperature options (3000K, 3500K, 4000K
and 5000K) — all within 2.5 MacAdam ellipses.
Certification
Intertek cETLus Listed. RoHS (Restriction of Hazard-
ous Substances) and Made in USA.
Battery Power Sentry lithium ion battery providing up to
1300lm(10W) for 90 minutes. UL924 listed. Class 2
compliant. Meets Title 20 CEC (California Energy
Commission) efficiency standards.
Environment
Suitable for dry, damp, and wet locations.
Operating temp.: -40°C to +50°C
-40°F to +122°F
Dimming Driver Osram Optotronic Outdoor LED Driver allows
tunable output currents to achieve infinite config-
urations of output. UL Class P recognized. 0-10v
interface can be wired as Class 1 or Class 2 cir-
cuit.
Packaging
Sustainably manufactured outside cardboard
box and biodegradable, protective poly-foam
luminaire inserts.
SPECIFICATIONS
WARRANTY
5-year limited warranty. Complete warranty terms can be located at:
https://starteklightingamerica.com/wp-content/uploads/2019/11/Hydro_Beam_Warranty.pdf
Note: Actual performance may differ as a result of installation environment and final application.
All values are design or typical values, measured under laboratory conditions, at 25°C (77°F) .
CONTROL
Sensor
Hubbell WASP2 Low Voltage Digital Passive Infrared PIR. Integrated day-
light sensor for daylight harvesting applications. 24VDC, 120/277/347VAC,
120/277/347VAC (2 outputs), 208/240VAC, & 480VAC input voltage.