How to make bracelets with beads

The general method of how to make bracelets with beads is to wrap beads with thick cords at two

sides and string beads with thin threads in the middle of “eight” shape braiding. Following details

of making a bracelet are shown.

Materials required for making

a bracelet

Waxed cord

Braid knitting thread

Bell

Beads

Needle

Glue

How to make bracelets with beads?

Love hobby craft gives you a tutorial on how to make bracelets with beads this time. I am sure that

you will enjoy your time in making a bracelet. As the bracelet below will absolutely make you pleased.

Step 1: make a loop

Prepare materials in the picture 1. Thread a

bell to a yellow waxed cord to the middle;

make a knot to fix it. Make a loop using

three strands of thread with the left side

short; bring the right side of cord to make a

loop through the hole in the middle.

Step 2: combine the cord and

thread

Tie the loop slightly. Thread the loop to the

left side of the cord. Tie off the thread to

make a knot. Bring the right thread down to

the right cord; place it over the left cord and

thread.

Are you satisfied with the ways of making a bracelet? The decorative sky blue beads make the

bracelet more attractive. If you like it, just do it by yourself by following how to make bracelets

with beads.

You can find beads at: http://www.lovehobbycraft.com/b-547-beads-gemstones.html

Step 3: go on braiding

Bring the thread down to wrap the left cord

and thread and over the right cord. Bring the

left thread down and over on the left. Take

out several beads; string them.

Step 4: string the beads

Braid the threads as is said above; tie up and

cut off one end of the thread. Bring the

thread down to the left and over to the right.

Slide a bead. Bring the thread down to the

right cord and over down to the left. Slide

the other bead.

Step 5: go on stringing the beads

Slide the beads in the same way above; tie

the thread tight each time you string a bead.

Fold the end of the cord to the thread. Twine

the cords with the thread.

Step 6: the ending work

Twine the cords; try the bracelet around

your wrist to see the size. Bring the thread

to a loop to be fixed; cut off the redundant

thread; leave a short space of the cords

untwined; glue the thread. You can string

the bell to the loop at the other end.