HOFF WALL SHELF

Keep these instructions for future use

INSTALLATION INSTRUCTIONS

RECOMMENDED TOOLS AND MATERIALS:

PencilLevel

Tape measurePower drill

#2 Phillips screwdriver

THIS PRODUCT INCLUDES:

A.

B.

C.

D.

(not to scale)

Glass shelfPosts x2Mounting plate x2Cover plate x2Mounting screws x2Drywall anchors x2 3/32” Allen wrench

A.B.C.D.E.F.G.

E. F.

G.

4600 Olson Memorial Highway | Minneapolis, Minnesota 55422 I www.roomandboard.com I 800.486.6554

7/1/20

1

2

3

Choose your installation location. Place the mounting plates and mark the anchor points with a pencil, tape measure and level. Remove mounting plates after marking.

Use a 3/16” drill bit and a power drill to drill a pilot hole at the four anchor point marks. Then use a screwdriver to drive the drywall anchors into the wall until they are flush with the wall surface. Use care not to drive the drywall anchors in past the surface of the wall. Doing so will decrease the hanging strength of your shelf.

Attach the mounting plates. Make sure the mounting plate’s set screw heads face downwards. Use a Phillips screwdriver to drive the mounting screws into the drywall anchors. Place the cover plates onto the mounting plates.

Insert the glass shelf into the posts and attach the assembly to the mounting plates. Make sure set screw openings on the posts face downwards. Use the provided 3/32” Allen wrench to tighten the set screws.

4

Alternative hardware may be required when mounting to a surface other than drywall.Consult a professional if you have any questions regarding proper installation.All mounting holes must be used for safe installation.

SPECIAL CONSIDERATIONS:

14.25”