www.hilti-me.com Health & safetyPackage 1 | May 2008 | SdR

TE 905TE 706 AVRTE 500

Tool complete and in good condition

Check that the power cable is not damaged

Do not pull the machine by the power cable

Choose the right consumable for the application

Check that the chisel is not worn out

Apply grease on the connection end before use

Insert the chisel and check it does not come out

Select the operating mode

Always wear protective equipment: helmet; safety shoes; gloves; earplugs; safety glasses; mask

Point the side handle in the correct direction 1) For right-handers 2) for left-handers

1 2

Safety checks, preventive measures & safe operating mode

BreakersIn the store room and before use

www.hilti-me.com Health & safetyPackage 1 | May 2008 | SdR

During and after use

Select the power requires: Middle pos. 100% - Right pos. 75% - Left pos. 50%

Select lock-button for continuous operation

Disconnect the tool (pull the plug not the cord)

Take out the chisel from the chuck

Standing up: always handle the tool with both hands

Working towards the ground: lean the machine against the thigh

Leave power cable behind the machine

When working towards the ground, always work towards the outside

Clean it after use and replace in its box

Safety checks, preventive measures & safe operating mode

www.hilti-me.com Health & safetyPackage 1 | May 2008 | SdR

TE 76-PTE 40 (AVR)

In the store room and before use

Tool complete and in good condition

Check that the power cable is not damaged

Do not pull the machine by the power cable

Choose the right consumable for the application

Check that the chisel is not worn out

Apply grease on the connection end before use

Position the side handle for left-handed or right-handed operators

Select the correct function according to the application: Breaking/Hammer drilling/Rotary drilling

Always wear protective equipment: helmet; safety shoes; gloves; earplugs; safety glasses; mask

Safety checks, preventive measures & safe operating mode

Combi-hammersTE 16 TE 56 (ATC)

www.hilti-me.com Health & safetyPackage 1 | May 2008 | SdR

During and after use

Leave power cable behind the machine

Always hold the machine with both hands

Never hold the machine by the chuck or drill bit

If power setting light is on, power is at 50%

Chiseling function lock-button

Standing handle the tool with both hands

In low position : handle the tool with both hands, and one knee on the ground

Disconnect the tool (pull the plug not the cord), clean it after use and replace in its box

Safety checks, preventive measures & safe operating mode