Embed Size (px)
Citation preview
Installation Instructions
Oil Cooler Guard
Suzuki GSXR1000
Installation Instructions
1 x Oil Cooler Guard A
2 x Rubber Bungs B
Product No: PRN013586
Kit Contents
1Installation Instructions
Please repeat on both side
2Installation Instructions
Please repeat on both side
3Installation Instructions
Please repeat on both side
4Installation Instructions
Pull fairing back and out to release from rubber
bung location
5Installation Instructions
6Installation Instructions
7Installation Instructions
8Installation Instructions
9Installation Instructions
10Installation Instructions
Caution
Lay a towel or cloth on the ground to stop damaging the
fairing
11Installation Instructions
Caution
Remove fairing by rotatingthe complete panel underneath
the bike
12Installation Instructions
Please repeat on both side
13Installation Instructions
14Installation Instructions
15Installation Instructions
OEM PART
16Installation Instructions
Locate round holesamongst hexagons.
Push Rubber Spacerthrough from the front of the guard
so Hexagonal shapesits on the back face
Caution
Install fairing by rotatingthe complete panel underneath
the bike
17Installation Instructions
18Installation Instructions
19Installation Instructions
20Installation Instructions
Locate the guardinside the fairing
21Installation Instructions
OEM PARTPlease repeat on both side
Installation Instructions 22
Reverse Stages9 - 1
Installation Instructions
It is recommended that periodic inspections are made to ensurethat dirt and debris have not become trapped between the guard
and the radiator/oil cooler. Such dirt and debris would reduce the cooling efficiency of the radiator/oil cooler.
It is recommended that periodic inspections are made to ensure that all fixings are fully tightend.
