Embed Size (px)
Citation preview
EnerSolis Series
Grid-connected Photovoltaic Inverter The EnerSolis series grid-connected Photovoltaic Inverter is delivered in a waterproof IP65 enclosure which can be installed in either a grid connected solar tracker system or a stationary PV system. By taking care of an accurate power conversion from solar panel to local grid, the EnerSolis series effects conversion process with minimal power loss and maximum reliability. Equipped with the intelligence MPPT process, it will always find the best working point, even under dynamic weather conditions. In this way, it reliably converts solar energy into solar yield. The heat that is lost is, to a great degree, dissipated via the heat sink on the rear of the unit. No fans, no problems, just long service life.
• Compact Size & low weight
• User Friendly LCD Display
• Use High MTBF Component
• Convection Cooling (Fan-less)
• Intelligence DSP Controller
• Protection class IP65
• Wide MPPT range of 100 to 400 Vdc
• Intelligence MPPT Technology
• Anti-islanding Technology
• RS232 and RS485 communication
• De-rating function
• High MPPT tracker efficiency
• Easy installation
ITEM
Inverter Technology
MODEL FS 2000
Sine-wave, Current source, High frequency PWM Conversion Mode
Isolation Method Transformer-less Design
DC Input Data
Nominal DC Voltage 365 Vdc
Max. DC Input Voltage 450 Vdc
Working Range 80 — 450 Vdc
Max. DC Input current 10.0 Amp
MPPT Range 100 — 400 Vdc
MPPT Tracker 1
AC Output Data
Nominal AC Power 1800 Watt
Max. AC Power 2000 Watt
Nominal AC Voltage 230 Vac (1-N)
Output Connect Method 1-Phase / 2-Wire
AC Voltage Rang 184V — 264.5V (Base on 230 Vac)
Nominal AC Current 7.82 Amp
Frequency 50 /60Hz
Power Factor > 0.99
Current Distortion Total Harmonic current : Less than 3%
Efficiency Data
Max. Efficiency 95.5%
Euro Efficiency 94.0%
Environmental
Operating Temperature -25 °C — -1-40 °C
Humidity 0 to 90% (Without condensation)
Altitude 0 — 2000 M
Mechanical
Dimensions (H x W x D) 352 x302 x 125 mm
Weight 9 kg
Protection Class IP65, outdoor
Cooling Convection
AC Connection Terminal
DC Connection Connector
Cornmun ication
Communication Interface RS232 & R5485
Front Panel
LCD
Boost input Voltage, Boost input Current, Boost input Power, AC output Voltage, AC output frequency, AC
output current, AC output power, AC Energy, yield, Inner Temperature, Heat sink Temperature, Status
message, Error message
LED
RED On: Ground fault or DC Input Insulation fault
Yellow On: Unit Error or Alarm
Green Flash: Standby or Sleeping mode
On: Normal Operation
Key Pad UP key / Down key / Function key / Enter key
Protection
Utility Over/under Voltage, Over/under Frequency
Ground fault, DC Isolation fault
Islanding operation detection Passive :Voltage phase jump detection
Active : Reactive power control
Over Temperature Downgraded output power
Certification
On-Grid Performance VDE0126-1-1, ENEL2010, A54777.2/.3, UKG83/1
Safety EN62109-1, A53100
EMI/EMC EN 61000-6-1, EN 61000-6-3, EN 61000-3-3
EnerSolis Series
Grid-connected Photovoltaic Inverter
Corporate Headquarters
Ablerex Electronics Co., Ltd.
1F, No. 3, Lane 7, Pao Kao Road, Hsintien 23114, Taipei Hsien, Taiwan
Tel: +886-2-2917-6857 Fax: +886-2-2913-1705 http://www.ablerex.com.tw Email: [email protected]
Asia Pacific Sales, Marketing and Service Office di I
Ablerex Electronics (S) Pte Ltd
No. 16 New Industrial Road #02-04 Hudson TechnoCentre Singapore 536204
Tel: +65 6228-6535 Fax: +65 6228-6343 http://www.ablerex.com.sg Email: [email protected]
![Design of Grid-Connected Photovoltaic System · weight of photovoltaic system [7]. The grid[6] -connected photovoltaic systems also need the inverters for power conversion, grid interconnection](https://img.dokumen.tips/doc/110x75/5fba0adb999fbb3bbe303c6e/design-of-grid-connected-photovoltaic-system-weight-of-photovoltaic-system-7.jpg)
