Generative Shape Design Tutorial.pptx

8/17/2019 Generative Shape Design Tutorial.pptx

1/14

Generative Shape Design Tutorial

Demonstrating Space Ball base Located on Desk


2/14


3/14

Show combine sketches command use to combinethe two predrawn sketches, then hide parentsketches, leaving only the combined outline.


4/14

"reate a point o#set $rom the origin, and explain

that this will be used in %ll sur$ace command.


5/14

Show %ll sur$ace command, explaining that it can beused to %ll any closed contour as long as a closing

point exists to help de%ne the sur$ace.


6/14

&nhide previously drawn bottom pro%le sketch,explaining that this was also created previously

using the spline command and that it will be usedto de%ne the base o$ the spaceball.

Sh lti ti $ d tili i th


7/14

Show multisection sur$ace command, utili'ing theoutline o$ the upper %ll sur$ace and the previouslyunhidden base outline as the bounds. (xplain thatthis command can be used to )oin any number o$

pro%les o$ any shape to create a sur$ace.


8/14

Show hollow shape


9/14

Show %ll command being used to close the bottompro%le o$ the spaceball, using the origin as the

closing point.


10/14

&nhide oval sketch and point


11/14

Show pro)ect command o$ oval sketch and pointonto sur$ace, explaining that the pro)ect commandcan be used to place an outline o$ any sketch onto

any shape sur$ace.


12/14

"reate sketch o$ a line, explaining that it willbe used $or the bump command, that we will

explain next, to de%ne direction o$ bump.


13/14

Show bump command, show the use o$ the linesketch $or direction, the de$ormation center point,

de$ormation boundary and how to change theshape o$ the bump.

Show edge %llet command by utili'ing it to blend


14/14

Show edge %llet command by utili'ing it to blendthe sharp edges o$ the bump into the spaceball

sur$ace. Show how to modi$y the radius o$ the %letin the properties menu. *ide the oval and line

sketches.

Documents

Generative Shape Design Tutorial.pptx