1

PARTS ASSEMBLYFORMULA ONE SERIES

From the flat, out-of-the-boxposition – rotate the right and left seat adjustment knobs to an upright position(approximately 90˚ angle)start your racing chair assembly

PARTS ASSEMBLYFORMULA ONE SERIES2

3PARTS ASSEMBLY

Lumbar PumpAssembly,plate (BB),screwinto place(3 chromebolts, lock-washers &washers)

Arm Restassemblybracket(AA)postion,screwinto place,(3 chromebolts, lock-washers &washers)

Shifter Knobscrews intoposition

(AA)

(AA)FRO

NT

Adjustment knobfaces front

BA

CK

Secure chair base armature to chairbottom with four bolts,lock-washer and washer

BackBolts

FrontBolts

1

2

3

4

ChromeBolts

FORMULA ONE SERIES

Coil springattachmentclip

(AA)

(BB)

(AA)

front shortbolts - base

back longbolts - base

chrome backetbolts - base

chrome backetbolts - base

PARTS ASSEMBLYFORMULA ONE SERIES

coil springattachmentclip

4

5

When your racing chair is fully assembled –1-position brake caliperkit over wheel base,2-insert chair post into wheel base, 3-positionsuspension coil overpost – and insert wheelbase unit into chair basesocket (snugly).

Snap into positionthe five (5) racingwheels in to chair base

Lift chair and wheelbase into the up-rightposition – the chairand wheel base willcompress in onecomplete chair unit.1

2

3

1

2

3

PARTS ASSEMBLYFORMULA ONE SERIES

Coil springattachmentclip

Lumbar PumpPosition and Hose Snap

Pump hose (female)snaps into chair hose (male) snap

Air valve adjustment knob, to close or release air

Lumbar Pump Assembly,screws into bottom base (BB)

Arm Rest – Three adjustable height settings

Lift each arm rest up and let it drop to bottom position, carefully lift up to desired height setting (3 settings – high, medium, low)

Squeeze pump to supply airto the lower lumbar inflatablecushion area to you desiredcomfort zone.

Lower lumbarinflatablecushion area

Bolted to chair base

Bolted to chair base

Bolted to chair base

PARTS ASSEMBLYFORMULA ONE SERIES6

Shifter Knob adjustments – Tap knob out for rockerposition (back and forth)

Tap in to lock chair position

Tap knob out for rocker

7

Tap knob in to lock

PA

RTS A

SSEMB

LYFO

RMULA O

NE SERIES

CAUTION:(Side adjustment knobs) The Formula One Series Chair IS NOT A RECLINER and BACK SEATSHOULD NOT BE RECLINED NOT MORE THAN 15% ANGLE

8

Shifter Knob height adjustments – Chair height adjustment

Push knob downto compress

While sitting in chair, (carefully)Push shifter knob down to compress chair to lowest position

While sitting in chair, (carefully) lift out of chair to while pushing shifter knob up to lift chair to yourcomfortable position

Push knob upto lift chair

PA

RTS A

SSEMB

LYFO

RMULA O

NE SERIES

Adjustment knob for resistance of forward and back motion of chair

Rotate knob to the desiredresistance level of forwardand back motion of chair

PITSTOP FURNITURE GARAGE ACCESSORIES