Click here to load reader
Upload
sunilvrv
View
174
Download
13
Embed Size (px)
DESCRIPTION
This is a example to simulate BULLET MODELING through FEA in LS dyna
Citation preview
1
Example 1: Bullet impact
2
Ex. 1: Bullet impactNew model
Ident BulletSymmetry 3D, Z
Load Materials – CART BRASS, FLOATGLASB, LEAD (Shock, Steinberg Guinan)Add erosion to all materials (geometric strain = 1.0)
Import parts from dyna: BulletInner.K and BulletOuter.K
Delete componentsCreate new component containing both partsTransform component
Rotate 180 degrees about Y-axisRotate 150 degrees about Z-axisTranslate –0.36mm in X direction
3
Ex. 1: Bullet impactDefine Initial Conditions
Name: InnerMaterial: LeadVelocity: X=519.6m/s, Y=-300m/sName: OuterMaterial: CART BRASSVelocity: X=519.6m/s, Y=-300m/s
Define Boundary ConditionsName: FixedType: General 3D VelocitySet all parameters to 0.0
Fill parts with initial conditionsFill Core with InnerFill Casing with Outer
Delete unused materials
4
Ex. 1: Bullet impactCreate Part
Name: TargetSolver: LagrangeSelect: Parts WizardPredef: BoxOrigin: (0.0,-50.0,0.0)Size: 2.5x100.0x50.0Numerical size: 5x50x25Grade Zoning
In J direction, 0.5mm,20 cells, centredIn K direction, 0.5mm,10 cells, lower K
Fill with FLOATGLASB
Convert part to IJK (from import pull down menu)
5
Ex. 1: Bullet impactDefine Group
Name: FixType: Nodes
Add nodes to groupUse Alt+left mouse button to draw polygon as shownUse Control+left mouse button to close polygon
Apply boundary condition “Fixed” to group
6
Ex. 1: Bullet impactJoin two parts of bullet together.
Define InteractionsCalculate gap size and check.
Define Wrap-up Criteria
Define Save times
Save and execute