* prepared for 48 kHz

�� Frequency range: 1.5 MHz – 30 MHz transmit and 10 kHz – 30 MHz receive�� HF@SATCOM speed: Up to 24 kHz bandwidth allows up to 120 kBit/s data transmission speed�� High dynamic conversion technology for outstanding co-site performance�� Optional automatic link establishment ALE 2 / 3 / 4 G�� Software defined architecture simply adaptable to upcoming standards by software upgrade �� LAN interface for remote control + audio (VoIP)�� Plug & play replacement of the well-known exciter / receiver ERX 3000

FEATURES

ERX 3003 /RX 3003HF Exciter / VLF-HF Receiver

ERX 3003 / RX 3003 – Pushing the Limits 24 kHz* wideband capabilitySoftware Defined HF Exciter/VLF-HF Receiver

OverviewWith its outstanding and new RF direct sampling technology this new radio boosts transceivers / receivers into the new generation of software defined radios (SDR) with 24 kHz 1) wideband capabilities.

Being compliant to air traffic management protocol ED 137 for HF, the radio can easily be integrated into air traffic con-trol systems.

The modular concept of the ERX 3003 allows incremental upgrades. The unit provides facilities for various radio com-munication applications. Different hardware- and software-based options are available. The equipment is designed to service various kinds of interfaces and hence simplifies integration into complex systems.

Transmitters and receivers can be combined to transceivers in split side operation to enable full duplex operation.

Furthermore the new ERX 3003 is fully compatible with its predecessor ERX 3000. Thus TRX 3xxx series is upgradable to HF wideband transceivers.

Enhanced features�� The optional 24 kHz wideband mode implemented in the new generation will boost the maximum data throughput in single sideband from 9,600 bps up to 120,000 bps compared to its narrowband predecessor�� Automatic link establishment ALE 4G in acc. with MIL-

STD-188-141 D app. G (24 kHz WALE)�� Without additional preselector the receiver desensitisation in traditional co-site environments is already comparable to classical analogue radios with a 40 dB preselector.�� Syllabic squelch�� Configurable parameters for different headsets�� Integration of new waveforms possible – in the base unit as well as on optional modem card

Logistical advantagesWith the ERX 3003, HMK remains faithful to the logistic concept of minimizing the provision of device-specific spare parts. The construction as well as the internal modules of the ERX 3003 are the same for all 150 W to 10 kW transmit-ters / transceivers. The stand-alone receiver RX 3003 also features identical modules, however, the transmit function is disabled by its software configuration.

ApplicationsThe ERX 3003 is the core unit of HF transmitters/transceivers from 150 W to 10 kW output power which are qualified for:�� Ship stations – in conjunction with the HF DSC Controller DSC 3002 also for GMDSS purposes�� Shore stations from 150 W to 10 kW HF transmitters�� Easy implementation into air traffic control management systems

1) radio is prepared for 48 kHz

The ERX 3003 is designed for semi-duplex voice and data transmission / reception and con-tains the complete exciter / receiver unit and reserves space for e.g. multifunction data mo-dem and configurations modules. The RX 3003 is using the receiver part only and is equipped with an additional built-in power supply.

ERX 3003 front view - night mode

ERX 3003

ERX 3003 / RX 3003 HF Exciter / VLF-HF Receiver

Implementation into an air traffic management (ATM) system

1 kW HF Transceiver TRX 3100 C

DSC controller DSC 3002 U

500 W HF Transceiver TRX 3050 C

500 W Antenna tuning unit ATU 3050

VoIP

SHORE STATION SAMPLE SHIP STATION SAMPLE

TECHNICAL DATA

Frequency range 1.5 MHz – 30 MHz transmit, 10 kHz – 30 MHz receive

Frequency resolution 1 Hz

Frequency tuning Via local keyboard and flywheel or remote control

RF output power 150 W / 500 W / 1 kW / 5 kW / 10 kW at 50 Ω with additional power amplifiers

Frequency stability < 1 x 10-8 per day

Freq. changing time ≤ 10 ms

Modes of operation

Standard AM (A3E), SSB (J3E USB/LSB), Data, USB/LSB/ISB, ISB (B9W), CW (A1A), FSK (F1B), AME (R3E, H3E, H3W), FM

HF wideband Up to 24 kHz

InterfacesI/O AudioHeadset

Remote control

VoIP

600 Ω balanced, 0 dBm adjustable Configurable parameters for different headset types possible Serial data RS232, 422, 485LAN 10/100/1000 BASE-T EthernetIAX, SIP, ED 137

Frontpanel socket Microphone 2 mV / 150 Ω PTT (0V = transmit)Interface for software updates/upgrades

Supply inputERX 3003

RX 3003

27 VDC – 29 VDC non floating, approx. 60 W(AC and floating DC optional)

100 VAC – 264 VAC, 47 Hz – 63 Hz appr. 60 VA (optional input for 21 VDC – 32 VDC, floating, appr. 60 W)

Environmental specifications

Operating temp. -15 °C to +55 °C

Humidity Max. 95 % up to 40 °C, non-condensing

Shock 15 g / 20 ms resp. 30 g / 10 ms with ½ sinus acc. to MIL-STD 810G, method 516.6

Vibration 4 Hz – 50 Hz, acc. to MIL-STD-810G,method 514.6 and MIL-STD-167-1

EMI/EMC Acc. to VG 95373/IEC 945and MIL-STD-461 C/462

Dimensions

Height 133 mm (3 U without rack)

Depth 426 mm (without handles)

Width 483 mm (19”)

Weight (without options)

9.5 kg

SPECIAL TOOLS AND FUNCTIONS

Software Download SWD 5000

If SWD 5000 software is installed on your computer you can manage the configuration of the radio. The configuration file will be loaded into the SLT 3003.

Software Loading Tool SLT 3003

Connect the SLT 3003 to the headset connector on the front panel of your radio and the updated configuration will be loaded into the radio.

Access Key AK 3003 The service tool protects access to initialization service and set-up area, preventing unauthorized settings of system parameters. Just plug-in the AK 3003 at the frontpanel headset connector.

Easy maintenance The construction of the ERX 3003 allows easy access to its modules. Especially exchanging of the built-in fan will take only minutes. Just unscrew a small cover at the bottom of the radio and pull out the combined fan/battery module.

Special tools

Software DownloadSWD 5000

Software Loading ToolSLT 3003

Access Ke yAK 3003

AK3003

ERX 3003 / RX 3003 HF Exciter / VLF-HF Receiver

Easy exchange of fan

150 W HF Transceiver TRX 3015 C or M

VLF - HF Receiver RX 3003 C or M

500 W HF Transceiver TRX 3050 C or M

1 kW HF Transceiver TRX 3100 C or M

5 kW HF Transmitter TX 3500 C or M

10 kW HF Transmitter TX 310k C or M

INTERNAL OPTIONS

NMEA interface For GMDSS functions

Data communication

Data rate depending on external modem

EXTERNAL OPTIONS

ATU 3015 150 W antenna tuning unit

ATU 3050 500 W antenna tuning unit

ATU 3100 1 kW antenna tuning unit

ACCESSORIES

For voice communication a bundle of accessories i.e. light and heavy headsets / handsets, goose microphone are available. Please specify your requirements, we will propose adequate items.

HARDWARE BASED CONFIGURATION MODULES (CCM)

With the unique hardware-based configuration modules the radio can be configured according to customer requirements. Sample configuration modules are:

CCM 3003 BACCM 3003 ATCCM 3003 ET

Configuration module – basicConfiguration module – air traffic controlConfiguration module – ETSI conform

Please contact us to assist you in the configuration of your radio.

HeadsetsMicrophonesATU 3015 ATU 3050 / ATU 3100

The new ERX 3003 is the common exciter for HF-transceivers from 150 W to 10 kW. The suffix of the radio’s designation shows its appli-cation: “C” for civil and “M” for military purposes.

HF RADIO FAMILY BASED ON ERX 3003

ERX 3003 / RX 3003 HF Exciter / VLF-HF Receiver

ERX 3003 / RX 3003 HF Exciter / VLF-HF ReceiverOptions for Military Applications

ADDITIONAL TECHNICAL DATA OR MILITARY OPTIONS

Modes of operation

L11

L22FH

Acc. to MIL-STD-188-203-1A, STANAG 5511 1) Acc. to STANAG 5522 1)

Acc. to STANAG 4444 2)

HF wideband up to 24 kHz2 Channel ISB

Acc. to MIL-STD-188-110C, Appendix D

Acc. to MIL-STD-188-110C, Appendix F 1) with external DTS / SPC, 2) with external FH controller

INTERNAL OPTIONS

4 Channel ISB Acc. to MIL-STD-188-110C, appendix F and MIL-STD-188-141B

ALE 2G *) Acc. to MIL-STD-188-141B

ALE 3G *) Acc. to STANAG 4538

Data communication *)

75 through to 120,000 bps acc. to MIL-STD-188-110C, Appendix D

*) realized with internal modem modules or external modem, depending on configuration

EXTERNAL OPTIONS

MDM 3010E Narrowband / wideband modem

ARQ 3010 E STANAG 5066 wideband node

ANTENNA TUNING UNITS (ATUs)

To connect your transmitter / transceiver to a narrow band HF antenna, an antenna tuning unit is required. For military appli-cations different versions are available, depending on output power and environment.

ATUs for surface vesselsATU 3050 AATU 3100 HVST

500 W 1 kW

ATUs for submarinesATU 3050 C

ATU 3050 G

ATU 3050 H

500 W, for installation into hoistable masts 500 W, for installation into hoistable masts 500 W, for installation inside the hull

CONFIGURATION MODULES (MCM)

Hardware-based configuration modules for military applications:

MCM 3003 LY Link Y config. module

MCM 3003 LK Link11 and / or Link22 and / or Link Y config. module

MCM 3003 FH Config. module for wideband wave-form, frequency hopping, Link 22 and Link 11 capability

Please contact us to assist you in the configuration of your radio.

�� HF wideband up to 24 kHz acc. to MIL-STD-188-110C, Appendix D�� Implemented sidetone receiver functionality for data LINK 11 / 22 operation�� Internal cryptography (voice and data) on modem card

ATU 3100 HVSTATU 3050 H ATU 3050 AATU 3050 C

SYSTEM AND OPERATIONAL CAPABILITIES OF HMK’S HF RADIOS WITH ERX 3003

Broadbandcombiners

Submarineantenna tuners

for hull

Submarineantenna tuners

for masts

Low voltageDC power

supply

High voltageDC power

supply

AC powersupply

3-phase AC power

supply

Voice communication Morse communication Message communication

CMS data LINK Y,LINK 11/22

communication

Accessories

STANAG 5066messaging

ACP 127teletype

communication

Frequencystandard

Remotecontrol

GMDSSDSC controller

HF widebandmodem/

ALE controller

VLF4-MSK/FSKdemodulator

HF-transceiver/transmitter150 W/500 W/1kW/5kW/10kW

with ERX 3003

Automatic link establishment

High speed modem

MIL chatXMPP chatSTANAG 4406X.400 military

messagingHF e-mail

Antennatuning

surface vessels

ERX 3003 / RX 3003 HF Exciter / VLF-HF ReceiverVersatile Radio Equipment Family for any Military Application

One of HMK’s core business are Integrated Communication Systems (ICS) for naval vessels and submarines. Our HF radio family has been designed for use under harsh environmental conditions, where simultaneous and fail-safe operation in a co-located multi-transmitter antenna environment is mandatory.

Transceivers from Hagenuk Marinekommunikation with the new HF exciter ERX 3003 are the perfect solution for modern radio systems. The following figure provides an overview of systems and operational capabilities with hardware and applications:

Over the last four decades, HMK has delivered more than 560 Integrated Communication Systems to 29 navies all over the world. We always aim for close cooperation and intensive dia-

logue with our clients, in order to develop turn-key solutions which fulfil their individual requirements.Whatever your application requires – HMK has the solution!

Prin

ted

in G

erm

any

Tec

hnic

al a

ltern

atio

ns re

serv

ed

©H

agen

uk M

arin

ekom

mun

ikat

ion

GmbH

18

6/10

_201

8

Hagenuk Marinekommunikation GmbHHamburger Chaussee 2524220 Flintbek | GermanyPhone: +49 4347 714-101Fax +49 4347 714-110info@hmk.atlas-elektronik.comwww.hmk.atlas-elektronik.com

Contact

ERX 3003 /RX 3003HF Exciter/ VLF-HF Receiver