Embed Size (px)
Citation preview
FLT CTRL NO DISPATCHReturn to Service Procedures
NOTE: FOR TRAINING PURPOSES ONLY.
IT DOES NOT SUPERSEDE EMBRAER
OFFICIAL DOCUMENTATION
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:002
AIRCRAFT MAINTENtANCE MANUAL (AMM) PART II – MAINTENANCE PROCEDURE
Go to Return-to-Service Test
(AMM Part II – Task 27-00-00-070-801-A)
1
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:003
ACCESS THROUGH CMC...
2
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:004
NVM CLEARING TEST:
GO TO:
•27 Flight Controls
• 03 Flight controls System;
•NVM CLEARING TEST
3
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:005
NOTE: CONFIRM ALL OF FCM
STATUS SHOW PASSED.
START NVM CLEARING TEST
4
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:006
CLEAR NVM
5
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:007
START FCS OPS TEST
6
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:008
NVM CLEARING TEST (4 of 7)
NOTE: in the begining of this step , observe that all of indicating dots are RED. After the item #1, the half of them becomes GREEN and after item #3, all of them will turn to GREEN.
CAUTION: It’s very important to ensure that the Control Column is really moved to the STOPS and stays there for at least 3 (THREE) seconds.
CAUTION: When cycling the FCP switch, when pressing it, wait 3 seconds before press it again to cycle the actuator
7
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:009
NVM CLEARING TEST ( 5 of 7 )
NOTE: in the begining of this step , observe that all of indicating dots are RED. After the item #1, the half of them becomes GREEN and after item #3, all of them will turn to GREEN.
CAUTION: It’s very important to ensure that the Rudder Pedals really are moved to the STOPS and stays there for at least 3 (THREE) seconds.
CAUTION: When cycling the FCP switch, when pressing it, wait 3 seconds before press it again to cycle the actuator
8
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:0010
NVM CLEARING TEST ( 6 of 7 )
9
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:0011
NVM CLEARING TEST ( 7 of 7 )
Note: It’s important to confirm that all of indicating dots on NVM CLEARING are GREEN. If one or more still RED, you must repeat the entire procedure.
10
FLIGHT CONTROLS – DISPATCH PROCEDURES
Issue: Jan, 2005 Rev.:0012
FINALLY, CHECK THE EICAS DISPLAY. .
THE MESSAGES:
• FLT CTRL NO DISPATCH
• FLT CTRL FAULT
ARE NO LONGER PRESENTED ON EICAS DISPLAY
11
THEN. . .
Power Down and Power Up the ACFT as required per SNL-170-27-0007.
