10

DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Page 1: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 2: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 3: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 4: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 5: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 6: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 7: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 8: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 9: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,
Page 10: DOHNÁLEK - ochrany pro energetikuGER.pdf · for turbogenerators it is commonly 1.5 < xq < 2.2, while for salient-pole machines, particularly for smaller-size salient- pole machines,