Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Design of an Experimental ORC Expander Setup Using Natural Working Fluids
Future restrictions on working fluids justify the need for further
research on ORC expanders using natural fluids. There is a lack of
experimental data in the open literature for this combination of
expanders and natural working fluids. In response to this
knowledge gap, NTNU has designed and is building EXPAND, an
experimental setup to characterize expanders in the 25–100 kW
power capacity using natural working fluids and their mixtures.
Ángel Á. Pardiñas ([email protected]), Marcin Pilarczyk, Roberto Agromayor and Lars O. Nord
NTNU - Norwegian University of Science and Technology, Department of Energy and Process Engineering, Trondheim, Norway
• Steady state facility.
• Expander power output: 25 – 100 kW.
• Natural working fluids and their mixtures.
• Flexibility (pressure ratios, mass flow rates, working fluids).
• Low-to-medium temperature of waste heat source < 150 °C.
• 1 bar < operating pressure < 20 bar (absolute).
• Gas phase operation (↓ fluid charge, ↓ cooling/heating needs).
Expander• Setup for volumetric and dynamic expanders.
• 1st approach: single-stage, axial turbine (≈ 50 kW) by ENOGIA.
• Coupled to frequency converter.
• Variable-speed operation.
• Supply the power generated from the expander to the compressors, reducing the power need from the grid.
Compressors• Turbocompressors are more compact, lighter and silent than
volumetric machines. No oil separation challenge.
• Flexibility with turbocompressor arrangement:
1. Low pressure lift - high mass flow rate mode.
2. High pressure lift - low mass flow rate mode.
▪ EXPAND was designed to operate in the gas phase to reduce the
heating and cooling duties as well as the charge of working fluid.
▪ The working fluid for the first experimental campaign is isobutane
(R600a) because it allows for operation with a broad range of
pressure ratios within the pressure constraints.
▪ The expander architecture for the first experimental campaign is a
variable-speed, single-stage, axial turbine.
This publication has been partly funded by HighEFF - Centre for an Energy
Efficient and Competitive Industry for the Future, an 8-year Research Centre under the
FME-scheme (Centre for Environment-friendly Energy Research, 257632). The authors
gratefully acknowledge the financial support from the Research Council of Norway and
user partners of HighEFF.
Motivation
System requirements and concept (Figure 1)
Expander and compressors
Working fluid selection
Conclusions
Acknowledgement
Figure 2. Saturation pressure and temperature of
several natural working fluids and feasible
operation region of the test rig.
Figure 3. T-s diagram of the test rig with isobutane
and pressure ratio of 3 (blue) and pressure ratio of
8 (red and green).
Suitable natural working fluids are those with psat-Tcurves falling within the rectangle defined by [15 °C, 150 °C] and[2 bar, 20 bar].
Isobutane as starting point.
Recuperator to reduce the cooling and heating capacities of the auxiliary loops.
Figure 4. Left, sketches of axial-radial and axial-tangential views of a single-stage, axial expander.
Right, turbocompressor arrangement used in EXPAND.
Comp LP 1
Comp LP 2
Comp HP
V2
V1Turbocompressor
Manual valve
Check valve
Figure 1. Process flow diagram of the EXPAND test rig.