www.partypaper.com | February 2011 | 37
Created by Chris Horne, Amscan International Ltd. Balloons
featured from Anagram International Inc., a division of Amscan Inc.
For more balloon bouquet ideas and to see the entire portfolio of
Anagram’s balloons, visit www.anagramballoon.com
Using Anagram’s Curves and Crescents is a perfect way to get
people dancing at your Halloween celebration.
Dancing Skeleton Bouquet
Instructions:
1. Inflate the two 15-inch Lime Green Curve balloons, two
10-inch Purple Crescent balloons and one 4-inch Star balloon with
air and heat seal.
2. Join the tails of the two 15-inch Curves together, securing
with a cable tie. Join one point from each Crescent together, also
securing with a cable tie.
3. Join the pairs of Crescents and Curves with a third cable tie
to form the mask as shown, securing the free points of the
Crescents to the Curves with small squares of hook-and- loop
tape.
4. Inflate all of the remaining balloons with helium and attach
to ribbons.
5. Arrange as shown in picture and attach to the weight.
6. Attach the mask to the weight by taking a short piece of
ribbon and tying through the loop on top of the weight and around
the center of the mask (where the cable ties are).
7. Then, to conceal all the cable ties and knots, cut any excess
ribbon and attach the 4-inch Star balloon to the center of the mask
using a small square of Hook-and-Loop tape.
Estimated Cost: $10Labor: 10-12 MinutesSuggested Retail Price:
$19.99-$29.99
Materials:• 1 36” Anagram Decorator Curve, Purple
(#16408-99)
• 1 36” Anagram Decorator Curve, Lime (#16423-99)
• 2 15” Anagram Decorator Curves, Lime (#16392-99)
• 2 15” Anagram Decorator Crescents, Purple (#16416-99)
• 1 4” Anagram Foil Star, Lime (#16413-99)
• 3 18” Dancing Skeletons (#20259-02)
• 1 Green Star Weight (#117800-03)
• Small cable ties
• Orange Curling Ribbon
• Self-adhesive Hook-and-Loop tape
Balloon Recipe
*Balloon decoration is intended for indoor use and should not be
released outdoors
View Balloon Recipes Online at www.partypaper.com
