2
CX-UA Series Optimization and Compression for Improved Backhaul Efficiency Extend network capacity for new services. Increase revenue by expanding the capacity of existing networks without forklift upgrades. Extend coverage area of new services leveraging legacy transmission infrastructure. Reduce cost of broadband access services and IP-RAN technologies. Maximize ROI time frames – often measured in just months. STRATEGIC AND TACTICAL UTILIZATION OF OPTIMIZATION AND AGGREGATION TECHNOLOGIES ACROSS 2G CIRCUIT-BASED NETWORK POINTS ALWAYS ENSURES A CONTROLLED AND EFFICIENT TRANSITION TO 3G. THIS SOLUTION ALSO MAXIMIZES PRECIOUS CAPEX BUDGETS WHILE SAFE-GUARDING EXISTING REVENUE STREAMS. Memotec’s CX-UA Series is a modular cellular backhaul platform delivering 2G/3G Radio Access Network (RAN) aggregation and traffic optimization. Deployed at the MSC/BSC/RNC hub locations and aggregation points across the RAN, the CX-UA Series enables mobile operators to optimize and aggregate traffic, and free up capacity to allow for quick deployment of new services over their existing network, without costly upgrades, and at a lower cost. Comprised of 3 products, the CX-UA Series includes: CX-UA 1100 Access Gateway: supports 24 x E1 and 6 Ethernet ports in a compact 1U format. CX-UA 2000 Aggregation Node: supports up to 48 x E1, 8 or 20 Ethernet ports and 2 STM-1 interface in a modular 2U chassis, with a processing capacity of up to 126 E1s. Microwave, or Fiber PDH/SDH Access Network CX-UA CX-UA CX-UA CELL SITE RAN CENTRAL OFFICE BSC GSM 1800 BSC CDMA RNC BSC GSM 900 CDMA GSM 900 GSM 1800 Node B STM-1 E1 or SMT-1 STM-1 E1 or STM-1 E1 or STM-1 E1 ATM Switching and Abis Payload Optimization CX-UA 9000 Hub Node: supports up to 256 x E1, 6 x STM-1, 4 x STM-4 and up to 38 x GE interfaces in a carrier grade 12U modular chassis, with a processing capacity of up to 1,008 E1s. Memotec’s CX-UA Series can optimize and aggregate traffic from every 2G/3G GSM/CDMA network interface available today: 2G CDMA 2G GSM (Abis/Ater optimization) 2G GSM (DCME at the A/E interfaces) 3G UMTS/CDMA (ATM cell aggregation) 3G IP-RAN / WIMAX (VLAN spanning) Traffic can be aggregated and pushed to the most efficient bearer link available, be it E1 (supporting ATM-IMA or MLPPP), Synchronous Ethernet (for migration to IP-RAN) or STM-1/STM-4. A FLEXIBLE MIGRATION PATH Today, the CX-UA series provides the means to ag- gregate 2G/3G traffic over existing SDH/PDH infra- structure, The same CX-UA equipment also provides the means to smoothly and seamlessly migrate 2G or 3G traffic over an IP/Ethernet transmission infrastructure, merging it with IP-RAN. With support for IP/MPLS protocols, Carrier Ethernet interfaces as well as E1 and STM-1/STM-4 connectivity, the CX-UA is an investment which will provide benefits for the life of the deploy- ment. 3G

CX-UA Datasheet GenY v7 - Memotecmemotec.com/wp-content/uploads/2014/05/CX-UA_Datasheet.pdf · backhaul platform delivering 2G/3G Radio Access ... Node B STM-1 E1 or SMT-1 E1

Embed Size (px)

Citation preview

CX-UA Series Optimization and Compression for Improved Backhaul Effi ciency

Extendnetworkcapacityfornewservices.

Increaserevenuebyexpandingthecapacityofexistingnetworkswithoutforkliftupgrades.

Extendcoverageareaofnewservicesleveraginglegacytransmissioninfrastructure.

ReducecostofbroadbandaccessservicesandIP-RANtechnologies.

MaximizeROItimeframes–oftenmeasuredinjustmonths.

STRATEGIC AND TACTICAL UTILIzATION OF OPTIMIzATION AND AGGREGATION TECHNOLOGIES ACROSS 2G CIRCUIT-BASED NETWORK POINTS ALWAYS ENSURES A CONTROLLED AND EFFICIENT TRANSITION TO 3G. THIS SOLUTION ALSO MAXIMIzES PRECIOUS CAPEX BUDGETS WHILE SAFE-GUARDING EXISTING REvENUE STREAMS.

Memotec’s CX-UA Series is a modular cellularbackhaul platform delivering 2G/3G Radio AccessNetwork(RAN)aggregationandtrafficoptimization.

Deployed at the MSC/BSC/RNC hub locationsand aggregation points across the RAN, theCX-UA Series enables mobile operators to optimizeand aggregate traffic, and free up capacity toallowforquickdeploymentofnewservicesover theirexisting network, without costly upgrades, and at alowercost.

Comprised of 3 products, the CX-UA Series includes:

CX-UA1100AccessGateway:supports24xE1and6Ethernetportsinacompact1Uformat.

CX-UA2000AggregationNode:supportsupto48xE1,8or20Ethernetportsand2STM-1interfaceinamodular2Uchassis,withaprocessingcapacityofupto126E1s.

Microwave, or Fiber

PDH/SDH Access Network

CX-UA

CX-UACX-UA

CELL SITE RAN CENTRAL OFFICE

BSC GSM 1800

BSC CDMA

RNC

BSC GSM 900

CDMA

GSM 900GSM 1800

Node B

STM-1

E1 or SMT-1

STM-1 E1 or STM-1E1 or STM-1E1

ATM Switching and Abis Payload Optimization

CX-UA9000HubNode:supportsupto256xE1,6xSTM-1,4xSTM-4andupto38xGEinterfacesin a carrier grade 12U modular chassis, with aprocessingcapacityofupto1,008E1s.

Memotec’sCX-UASeriescanoptimizeandaggregatetrafficfromevery2G/3GGSM/CDMAnetworkinterfaceavailabletoday:

2GCDMA2GGSM(Abis/Ateroptimization)

2GGSM(DCMEattheA/Einterfaces)

3GUMTS/CDMA(ATMcellaggregation)

3GIP-RAN/WIMAX(VLANspanning)

Traffic can be aggregated and pushed to the mostefficient bearer link available, be it E1 (supportingATM-IMA or MLPPP), Synchronous Ethernet (formigrationtoIP-RAN)orSTM-1/STM-4.

A fLEXIBLE MIGRATIOn PATH

Today, the CX-UA seriesprovides the means to ag-gregate 2G/3G traffic overexisting SDH/PDH infra-structure,ThesameCX-UAequipment also providesthe means to smoothlyand seamlessly migrate2G or 3G traffic over anIP/Ethernet transmissioninfrastructure, merging itwithIP-RAN.

With support for IP/MPLSprotocols, Carrier EthernetinterfacesaswellasE1andSTM-1/STM-4 connectivity,theCX-UAisaninvestmentwhich will provide benefitsfor the life of the deploy-ment.

3G

CX-UA

E1 or SMT

E1 or STM-1

FEATURES AND CAPABILITIES

IP/Ethernet ElectricalandopticalSynchronousEthernet

Ethernetswitching/bridging

Ethernetbundling(802.3ag)

MLPPP

MPLS/POS*

Ethernet[VLAN]bridging

UDP/IPheadercompression

Multi-service pseudowire ATMpseudowire

HDLCpseudowire

VLANpseudowire

TDMcompressedpseudowire(proprietaryCESoP)

StandardTDMCESoPandSAToPpseudowire*

Abis SupportsGSMFR,EFR,HRandAMRcodecs

TransparentGSMcodecspeechframeforwarding

IDLEandsilencesuppression

HDLCsignalingframeextractionandforwarding

DynamicAbismapinterfaceauto-configuration

TRXchannelsusagereal-timemonitoring

Signaling/Voice/Datatrafficprioritization

(*)Futurerelease:checkroadmap

TDM Non-blockingVC12dropandinsertsupportonall

STM-1interfaces

APS1+1onallSDHinterfaces

E1portprotection

PCM/DCME SupportsG.729andG.723.1codec

SS7bandwidthreduction

Transparentfaxandmodemsupportwithcompression

Transcoderfreeoperation

Echocancellingto128msec

Provides20:1gainwithMemotecbandwidthmanagement

MANAGEMENT CentralizedEMSwithGUI,interactivehelpandCLI

ASCIIscriptfilegeneration

OpenstandardSNMP,CORBAbasedNMSplatform

CLIinterface(localorTelnetremoteaccess)

TNMcompliantNMSplatformwithnetworkmonitoring,inventoryandservicemanagement

AbisandvoiceinterfacedetailedalarmandperformancemonitoringwithKPI

Securedin-bandnodemanagement(IPbased)

T1/E1alarms:red,yellow,near/farendLOS,AIS,LOF,LOMF,test,loop

SYNCHRONIzATION ETSIPDHITU-TG.823/G.824andETSISDHSEC/

ITU-TG.813/G.825clocksynchronisationcompliant

Nx8KHz,10MHz,2.048MHz,1.544Mbps(BITS),and2.048MbpsG.703externalclockreferenceinput

8KHz,2.048MHz,1.544Mbps(BITS),and2.048MbpsG.703clockreferenceoutput

OptionalembeddedGPSclockmodule(CX-UA1100)

ENvIRONMENTAL Inputpower:DC-40Vto-60V

Operatingtemp:0°to50°Celsius

Storagetemp:-40°to+80°Celsius

Operatinghumidity:0to95%non-condensing

APPROvALS Safety:CSA/UL60950-1,IEC/EN60950-1

Telecom:TBR12,TBR13,FCCpart68

A SubSidiAry of ComteCh ef dAtA

[email protected],Montreal,QuebecCanadaH4S1P7

www.memotec.com www.memotec.mobi (from your PDA)

GENY1109v1

CAPACITy E1 PortVC12 TDM

CrossconnectE1 ATM IMA,

PWE or MLPPPE1 Abis/

Ater E1 DCMEEthernet

ElectricalEthernet

OpticalSTM-1

SupportSTM-4

SupportI/O

RedundancyAG

Redundancy

CX-UA1100 24 24x24 upto16 upto24 upto24 4 2 n/a n/a 1:1(option) n/a

CX-UA2000 16or48 126x126 upto126 upto126 upto63 4or16 4 2+2 n/a n/a n/a

CX-UA9000 upto256 1008x1008 upto1008 upto1008 upto5041+1(AG)

+upto32(I/O)2+2(AG) 6+6 4+4 1:N 1:1

PHySICAL # of slots Height Max consumptionETSI 600 half-rack

19” chassis

CX-UA1100 n/a 1U 30W W367xD260mm

CX-UA2000 2 2U 60W W367xD260mm

CX-UA9000 19 12U 600W W367xD260mm

AllCX-UAplatformsaredesignedaccordingtothemoststringentcarriergradestandards,andoffer1+1and/or1:nredundancyoptions.TheMemotec’sCX-UASeriesleveragesthetransmissionandprotocolexpertiseoftechnologypartnerPortugalTelecomInovoção,offeringmobileoperatorsacost-effective,yetprovensolutionfordeployingprofitable2Gand3Gservicesovertheirexistingandfuturetransmissionnetwork.

InTERfACES*

Digital E1 unframed,fractional,channelizedTDM Synchronous Ethernet 100/1000Mb/s,RJ45orSFPplug-inmodule

E1 line type G.703/G.704withorwithoutCRC4&MF STM-1/STM-4 SDH channelized VC12 interface, SfP connector

E1 encoding HDB3,AMI,NRZ,NRZi,75or120Ohms RS232 Serial craft interface

nfAS, AIS and RDI bits/alarm relay I/O Blades options 16portSMBor24portRJ21(Champ)

Balanced 120 Ohms (CHAMP) or unbalanced 75 Ohms (Mini SMB) connectors

* E1 interfaces may be used as either trunk, connecting to NodeB, CDMA or GSM BTS, or bearer, connecting to the RAN transmission network. Synchronous Ethernet interfaces are available to support IP RAN or IP/Ethernet based transmission equipment. STM-1/STM-4 optical/electrical interfaces are available in lieu of E1s if the E1 ports are already aggregated via ADM (freeing up E1 port capacity for trunk or bearer support).