Msc.dipl.ing Ante Bosancic IWE/EWE,IWI-C CV QA/QC Welding Inspector / Supervisor - Development of welding procedures - Development and implementation of quality systems. - Quality inspection during all stages of manufacturing - Review and approval of welding procedures,procedure qualifications, work procedures, NDT procedures and mechanical testing of materials - Quality assurance and control - Report deficiencies and advice on improvement - Review of NDT reports and actual witnessing of testing Checking that the welding procedures to be used are approved and duly qualified as required. • Monitoring the capability of each welder on the basis of Radiographic Reports. Checking the correct measurement of hardness when required and the acceptability of the results. • Checking all welding activities is in compliance with the applicable code, standards and specification. • Monitoring & witnesses of WPS/PQR • Co-ordination with Third party as well as client related to welding and NDT activities. • Review of mill certificates, consumable test certificates and calibration certificates of equipments. • Checking that only approved electrode, wires and gas are used. • Randomly checking welding parameters according to approved WPS (Ampere, Voltage, Travel Speed and Gas flow rate), •Checking the adequacy of equipment for preheating, welding, heat treatments and weld examinations. • Ensuring that weld inspection, examination and test are carried out and documented in accordance with the Quality Control Plan for site activities, verifying the inspection records and validating the relevant results. • Filing and retaining NDT reports and inspection reports. • Monitoring of the welding activities, checking in particular the adequacy of joint preparation protection and provision in case of rain, wind, low temperature etc. • Checking the adequacy of the heat treatment technique and the recorded diagram. • Checking the repairs is correctly made. • Checking the heat treatment diagrams. • Checking the issuance of the document required by contract specification
- Development of welding procedures- Development and
implementation of quality systems.- Quality inspection during all
stages of manufacturing- Review and approval of welding
procedures,procedure qualifications, workprocedures, NDT procedures
and mechanical testing of materials- Quality assurance and control-
Report deficiencies and advice on improvement- Review of NDT
reports and actual witnessing of testing
Checking that the welding procedures to be used are approved and
dulyqualified as required. Monitoring the capability of each welder
on the basisof Radiographic Reports. Checking the correct
measurement of hardness whenrequired and the acceptability of the
results. Checking all weldingactivities is in compliance with the
applicable code, standards andspecification. Monitoring &
witnesses of WPS/PQR Co-ordination with Thirdparty as well as
client related to welding and NDT activities. Review ofmill
certificates, consumable test certificates and
calibrationcertificates of equipments. Checking that only approved
electrode, wiresand gas are used. Randomly checking welding
parameters according toapproved WPS (Ampere, Voltage, Travel Speed
and Gas flow rate),Checking the adequacy of equipment for
preheating, welding, heat treatmentsand weld examinations. Ensuring
that weld inspection, examination and testare carried out and
documented in accordance with the Quality Control Planfor site
activities, verifying the inspection records and validating
therelevant results. Filing and retaining NDT reports and
inspection reports. Monitoring of the welding activities, checking
in particular the adequacyof joint preparation protection and
provision in case of rain, wind, lowtemperature etc. Checking the
adequacy of the heat treatment technique andthe recorded diagram.
Checking the repairs is correctly made. Checkingthe heat treatment
diagrams. Checking the issuance of the document required by
contract specification
