1 English Package Contents GIGABYTE AirCruiser Router with SmartSetup3 Ethernet Network Cable Power Adapter User Guide on CD-ROM AirCruiser Quick Start Guide & SmartSetup 3 Connect the Broadband Router A. Make sure you have the ISP login information for your Internet connection handy. This information is normally given to you when you registered for the Internet account. You can also call your ISP for these settings. B. Make sure all networking, DSL/Cable modems, and PC’s are turned OFF. C. Connect one end of RJ-45 Ethernet network cable (included) from your PC’s Network Interface Card (NIC) to any one of the Router’s four (4) LAN ports. D. Repeat above step to connect any other wired networking device. E. Connect the terminal end of your DSL or cable modem network line to the Router’s WAN (Internet) Port. F. Power on your DSL or cable modem. G. Connect the AC power adapter to the Router’s power port, and then plug the adapter into the wall socket. H. Make sure the power, LAN and WAN LEDs are illuminated green. I. Unit will self test for approximately 5 seconds. J. Power on the PC you connected to the router in Step C. Configure the Router Note: Make sure your PC’s TCP/IP Ethernet adapter is set to “Obtain an IP address automatically”. For more information see Windows Help.
![How–To setup Wi-Fi Client Router Mode as [CPE] connect to [WISP AP] & Using Existing Broadband Router to Create New Sub-Network](https://img.dokumen.tips/doc/110x75/55654719d8b42ad7648b51b7/howto-setup-wi-fi-client-router-mode-as-cpe-connect-to-wisp-ap-using-existing-broadband-router-to-create-new-sub-network.jpg)
