Embed Size (px)
Citation preview
1A
STEP 2STEP 1
1) Assemble cloud profiles 1A & 1B as shown.Note position of mounting slits. 2) “Partial Assembly X” is complete. Put this aside for later.
PARTIAL ASSEMBLY X
PARTIAL ASSEMBLY X
1B
DRANTE CLOUDASSEMBLY
2
3
4
5
5 4 3 2
STEP 4STEP 3
3) Assemble cloud profiles 5,4,3 & 2 as shown.
PARTIAL ASSEMBLY Y
4) Create 2 of the above assemblies.
x2
DRANTE CLOUDASSEMBLY
5) Interlock the two assemblies created in the previous step.
STEP 6STEP 5
6) “Partial Assembly Y” is complete.
PARTIAL ASSEMBLY Y
PARTIAL ASSEMBLY Y
DRANTE CLOUDASSEMBLY
STEP 8
7) Join “Partial Assembly X” with “Partial Assembly Y”as shown. 8) Assembled “Drante Cloud”.
STEP 7
Note position of mounting slits.PARTIAL ASSEM. Y
PARTIAL ASSEM. X
DRANTE CLOUDASSEMBLY
9) Place cloud assembly up to ceilingin desired location. Mark position of4 off through holes which correspondto the mounting slits.
11) Feed swaged wire through tipof ‘wire adjuster’ (as shown).Push button (shown in grey) toadjust wire length. Release the button to lock in place.
WIRE ADJUSTER
SWAGED WIRE
12) Feed swaged wire through hole in the side of ‘hanger head’. Screw ‘wire adjuster’into ‘hanger head’, then adjust wires so they finish at approx. the same length.
PUSH HERE
STEP 11 & 12
AD
JUST
LEN
GTH
a. b.
10) Consulting the “BaresqueSystems Fixing Directory”, select the appropriate fixing method for your substrate & install 4 off ‘hanger heads’. Please note, screws are not supplied.
CEILING
CEILING
STEP 9 & 10
DRANTE CLOUDSUSPENSION METHOD
*Please note, above linework is representative only. Your cloud may not be depicted.
15) Re-adjust wire length as explained in STEP 5 until cloudhangs level. Trim excess wire for a neat finish.
TRIM IF NECESSARY
13) Insert ‘S’ hooks into mounting slits oncloud as shown.
14) Suspend cloud by looping ‘S’ hooks through swaged wire.
SS SWAGED WIRE
‘S’ HOOK INMOUNTING SLIT
STEP 13 & 14 STEP 15
DRANTE CLOUDSUSPENSION METHOD
PROFILE 1A1 OFF
PROFILE 1B1 OFF
PROFILE 24 OFF
PROFILE 34 OFF
PROFILE 44 OFF
PROFILE 54 OFF
HANGER HEAD4 OFF
‘S’ HOOK4 OFF
WIRE ADJUSTER4 OFF
SWAGED WIRE4 OFF
DRANTE CLOUDPARTS
