1

CCNA 2 Module 1 WANs and Routers

2 2 2

Purpose of This PowerPoint

• This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA version 3.0.

• It was created to give instructors a PowerPoint to take and modify as their own.

• This PowerPoint is:

NOT a study guide for the module final assessment.

NOT a study guide for the CCNA certification exam.

• Please report any mistakes you find in this PowerPoint by using the Academy Connection Help link.

3 3 3

To Locate Instructional Resource Materials on Academy Connection:

• Go to the Community FTP Center to locate materials created by the instructor community

• Go to the Tools section

• Go to the Alpha Preview section

• Go to the Community link under Resources

• See the resources available on the Class home page for classes you are offering

• Search http://www.cisco.com

• Contact your parent academy!

4 4 4

Objectives

• WANs

• Routers

5 5 5

Introduction to WANs

• A wide-area network (WAN) is a data communications network spanning a large geographic area such as a state, province, or country.

6 6 6

WAN Devices

7 7 7

WAN Services

8 8 8

Data Link Encapsulations

9 9 9

Internal Configuration Components

10 10 10

Routers Connected by WAN Technologies

11 11 11

Network Layer Path Determination

12 12 12

Internetwork Routers

• Any internetwork must include the following:

Consistent end-to-end addressing

Addresses that represent network topologies

Best path selection

Dynamic routing

Switching

13 13 13

Academy Approach to Labs

• In the academy lab, all the networks will be connected with serial or Ethernet cables and the students can see and physically touch all the equipment.

• Devices that make up the WAN cloud are simulated by the connection between the back-to-back DTE-DCE cables.

14 14 14

Router Internal Components

15 15 15

Router Internal Components

16 16 16

Internal Components of a 2600 Router

17 17 17

External Connections on a 2600 Router

18 18 18

Router External Connections

19 19 19

Computer or Terminal Console Connection

20 20 20

Modem Connection to Console or Auxiliary Port

21 21 21

Connecting Console Interfaces

1. Configure terminal emulation software on the PC for the following:

The appropriate com port

9600 baud

8 data bits

1 stop bit

No parity

No flow control

2. Connect a rollover cable to the router console port (RJ-45 connector).

3. Connect the other end of the rollover cable to the RJ-45 to DB-9 adapter

4. Attach the female DB-9 adapter to a PC.

22 22 22

Connecting LAN Interfaces

23 23 23

Router Serial WAN Connectors

24 24 24

DCE Serial Connections