1 © 2003, Cisco Systems, Inc. All rights reserved.

CCNA 2 Module 6 Routing and Routing Protocols

2 2 2 © 2003, Cisco Systems, Inc. All rights reserved.

Purpose of This PowerPoint

• This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA version 3.0.

• It was created to give instructors a PowerPoint to take and modify as their own.

• This PowerPoint is:

NOT a study guide for the module final assessment.

NOT a study guide for the CCNA certification exam.

• Please report any mistakes you find in this PowerPoint by using the Academy Connection Help link.

3 3 3 © 2003, Cisco Systems, Inc. All rights reserved.

To Locate Instructional Resource Materials on Academy Connection:

• Go to the Community FTP Center to locate materials created by the instructor community

• Go to the Tools section

• Go to the Alpha Preview section

• Go to the Community link under Resources

• See the resources available on the Class home page for classes you are offering

• Search http://www.cisco.com

• Contact your parent academy!

4 4 4 © 2003, Cisco Systems, Inc. All rights reserved.

Objectives

• Introduction to static routing

• Dynamic routing overview

• Routing protocols overview

5 5 5 © 2003, Cisco Systems, Inc. All rights reserved.

Route Types

6 6 6 © 2003, Cisco Systems, Inc. All rights reserved.

Specifying Outgoing Interface

7 7 7 © 2003, Cisco Systems, Inc. All rights reserved.

Specifying the Next-hop IP Address

8 8 8 © 2003, Cisco Systems, Inc. All rights reserved.

Configuring Static Routes

9 9 9 © 2003, Cisco Systems, Inc. All rights reserved.

Non-directly Connected Networks

10 10 10 © 2003, Cisco Systems, Inc. All rights reserved.

Verifying Static Route Configuration

• The command show running-config is

used to view the active configuration in RAM to verify that the static route was entered correctly.

• The show ip route command is used to

make sure that the static route is present in the routing table

11 11 11 © 2003, Cisco Systems, Inc. All rights reserved.

Troubleshooting Static Route Configuration

• The show interfaces command

• The ping command

• The traceroute command

12 12 12 © 2003, Cisco Systems, Inc. All rights reserved.

Routed Versus Routing Protocol

13 13 13 © 2003, Cisco Systems, Inc. All rights reserved.

Autonomous Systems

14 14 14 © 2003, Cisco Systems, Inc. All rights reserved.

Dynamic Routing Operations

15 15 15 © 2003, Cisco Systems, Inc. All rights reserved.

Classes of Routing Protocols

16 16 16 © 2003, Cisco Systems, Inc. All rights reserved.

Distance Vector Concepts

17 17 17 © 2003, Cisco Systems, Inc. All rights reserved.

Distance Vector Network Discovery

18 18 18 © 2003, Cisco Systems, Inc. All rights reserved.

Routing Metric Components

19 19 19 © 2003, Cisco Systems, Inc. All rights reserved.

Link-State Concepts

20 20 20 © 2003, Cisco Systems, Inc. All rights reserved.

Link-State Network Discovery

21 21 21 © 2003, Cisco Systems, Inc. All rights reserved.

Link-State Topology Changes

22 22 22 © 2003, Cisco Systems, Inc. All rights reserved.

Link-State Concerns

23 23 23 © 2003, Cisco Systems, Inc. All rights reserved.

Path Determination

24 24 24 © 2003, Cisco Systems, Inc. All rights reserved.

Routing with Network Addressing

25 25 25 © 2003, Cisco Systems, Inc. All rights reserved.

IP Routing Configuration Tasks

26 26 26 © 2003, Cisco Systems, Inc. All rights reserved.

Using the router and network Commands

27 27 27 © 2003, Cisco Systems, Inc. All rights reserved.

Routing Protocols

28 28 28 © 2003, Cisco Systems, Inc. All rights reserved.

Interior/Exterior Routing Protocols