Calibration Guide

How to calibrate yourQED sensor after installation.

Necessary Parts

Level

Necessary Tools

Calibration Chart

Step 1:Open the “This PC” app.

Step 2:Click the Local Disk (C:)Drive.

Step 3:Click the “Z3CAMSensor” folder.

Step 4:Inside “Z3CAMSensor”

“Z3_CAM_TOOL”

Step 5:Inside the “Z3_CAM_TOOL”Make sure the status areall green.(If status is not greenplease contact support@uneekor.com)

Step 6:Check the “Center Cam”and “Side Cam.” Makesure they are on. Adjustbrightness if needed. If you do not see anything, please refer to

in the install link.

Step 7:If steps 5 and 6 passed,place the calibrationchart on the hittingmat. Make sure the center line on the chartis straight on the “centercam” ONLY.

Step 9:Then click the “Calibration” button.You will see some thingshappening in both cameras. Please waituntil you get a message.

(Make sure your hitting mat is level! If not you will getinaccurate shot data)

Step 8:It is important the center line is straightand circle tee position iscloser towards the backaway from the hittingscreen. See diagram.

Hitting Screen Hitting Screen

Step 10:If calibration is successful you will see this message. Click

(If calibration failedplease contactsupport@uneekor.com) Step 11:

check to see if you seea grid of green dots onboth cameras. Thenmove onto “Area Setting.”

Step 12 :In the “Area Setting”menu, you will see this.In here you are able toclick and drag the green box to adjust your hittingzone. The box must staywithin the green dots.and close to center.

Step 14 :

button.

Step 15 :Then on the next page

with calibration.

Step 13 :Make sure the “OneArea Mode” is on.