5/21/2018 C3 Multi Band Compressor 1_2 Manual
1/3
C3 Multi Band Compressor version 1.2.9
C3 Multi Band Compressor is a free VST plugin. C3 is a three
band compressor that hasdividing filters(ButterWorth IIR or
LinearPhase FIR), three stereo compressors and
alimiter.*SamplingRate: 44.1k, 48k, 88.2k, 96k support*StereoOut:
(mono->stereo, stereo->stereo)support*32bit float internal
precision
f1:Set the cutoff frequency of the LowBand.
f2:Set the lower cutoff frequency of the MidBand.
f3:Set the higher cutoff frequency of the MidBand.
f4:Set the cutoff frequency of the HighBand.*The range of cutoff
frequencies is 20Hz to 20kHz.
MasterGain:Set the output level of C3.
Limiter(On/Off):Switch the limiter, On/Off. Maximum output level
is 0dB.
FilterSelect(BW IIR - LP FIR):Select the filter type,
ButterWorth IIR(24dB/oct) orLinearPhase FIR.*I recommend
LinearPhase FIR for mastering.
mute:Mute the output of each band.
comp on/bypass:Switch the each compressor, On/Bypass.
input/output:Switch the signals of each band meter,
Input/Output.
Reduct.:The meter of gain reduction.
Threshold(0dB to -60dB):Set the threshold level of
compressor.
Ratio(1:1 to oo:1):Set the ratio of compression.
Attack(0.1ms to 100ms):Set the attack time of compression.
Release(10ms to 1000ms):Set the release time of compression
Gain(-oodB to 17dB):Set the output level of each band. This
control effects at both "comp
on" and "bypass".
Knee:Set the softness of compressor's character.
#installCopy "c3multibandcomp_1_2.dll" to the VST plugin folder
of your host application.
And "msvcr71.dll"is need to run. If "msvcr71.dll" isn't
installed, copy "msvcr71.dll" toyour windows system folder (ex.
system32).
#uninstallDelete "c3multibandcomp_1_2.dll".
http://www.ismusic.ne.jp/slim_slow_slider/vst/[email protected]
Version History2004/10/13 version 1.2.9improve the algorism of
"attack time" detection.2004/7/5 version 1.2.8renewal of the
limiter section.2004/5/30 version 1.2.7
