Blade System Assembly

40”W x 4’x6”H Blade System Assembly

Maximum of (10) Pre-Cut Zintra Vertical Blade Profiles(2) Notched Anodized Aluminum40”x1”x1” SHS Wall Installation Supports(4) PVC 1”x1” End Caps

40”W x 9’-0”H Blade System Assembly

Maximum of (10) Pre-Cut Zintra Vertical Blade Profiles(3) Notched Anodized Aluminum40”x1”x1” SHS Wall Installation Supports(6) PVC 1”x1” End Caps

1. Locate (2) or (3) 40”Wx1”x1” aluminum notched supports (depending on height of system) and lay out each piece so the spacing between notched supports is even, making an “X” in the center of each notch on the support.

2. Template the location of each notched supports onto the wall substrate.

hex head screw required for panel to fit within notch and not protrude out past the support.

#8 drywall screw (hex head) recommended / Tapcon (hex head) for concrete substrates.

Note: notches are located every 12” apart on each aluminum support.

3. Drill supports and attach each support to the wall substrate using #8 drywall screws for each notch as shown below. Installer to source all screws/anchors for wall substrate.

4. Once all supports have been installed with equal distance in between - recommended 8” from the finished floor, locate 1”x1” PVC end caps. (4) for 4’-6”H systems and (6) for 9’-0”H systems.

5. Gently push each of the PVC 1”x1” caps onto the exposed ends of each notched aluminum support.

6. Locate first pre-cut vertical profile blade (#1) and insert into each of the left-hand notches of the aluminum supports matching to the corresponding notches in the profile piece.

7. Repeat #6 for each of the remaining vertical blade profile pieces (2-10 working left to right) until the system has been completely assembled.