BANDAGING

101

There are dozens of different bandaging methods designed for specific areas of the body or specific purposes.

The two areas most commonly bandaged are the abdomen and the legs.

BANDAGING

The abdominal bandage is commonly called the bellyband.

It is used after abdominal surgery to prevent the animal from licking the incision and to keep it clean.

It is also used if an injury has occurred in the abdominal area. Its purpose then is to control fluid leakage, keep medication on the wound, and keep the wound as sterile as possible.

ABDOMINAL BANDAGE

The bellyband consists of four layers: a sterile non-stick pad a layer of absorbent cotton a layer of gauze a final layer of adhesive bandage

ABDOMINAL BANDAGE

The main goal when applying a bellyband is to keep it snug and smooth so that it is comfortable and less likely to slip loose.

It is important not to apply it too tightly since this will cause patient discomfort.

ABDOMINAL BANDAGE

To apply a bellyband, start at the front of the abdomen and wrap towards the back overlapping the edges of the bandage.

When you reach the back, wrap the bandage towards the front, continuing to overlap the edges.

Each layer should be wrapped front and back at least one time.

ABDOMINAL BANDAGE

Leg bandages are generally applied for the purpose of covering an open wound, lending support to the leg, or securing a catheter.

LEG BANDAGES

Leg bandages for wounds or catheters usually have four layers: a non-stick pad absorbent cotton gauze adhesive bandage

LEG BANDAGES

Support leg bandages are mostly used on horses.

These bandages consist of a cotton or quilt layer and an elastic bandage.

Whenever a bandage is applied to a horse’s leg it should be started on the outside of the leg and wrapped towards to back of the leg.

This will support the tendons and ligaments of the leg.

LEG BANDAGES

http://peer.tamu.edu/VBB/VideoProcedures.asp

DEMONSTRATION