Upload
others
View
6
Download
0
Embed Size (px)
Citation preview
839 Bill France Boulevard, Daytona Beach, FL 32117 Phone: (386) 274-2079 Fax: (386) 274-2279 www.DavidsonSales.com
P20-D-1/2-EMCP3
Au
to S
tart
Gen
era
tor
Co
ntr
ol
Pa
nel
ST
AN
DA
RD
FE
AT
UR
ES
■ Specifically designed to retrofit the CAT EMCP 3 controller. Non-proprietary controls allows for infinite control
programming changes to suit the application or customer’s needs. Wired and pinned directly to a CAT 70 pin
connector for plug and play installation.
■ Basler DGC-2020 controller with; 15 outputs, 16 programmable inputs & RS-485 COM. Multifunction engine
and generator protection and metering including ECU specific parameters, when used with SAE J1939 Engines.
■ Front panel configurable. Full programmability and advanced configuration via included Basler BESTCOM Plus
software and included USB Standard (A) to (B) cable. External USB port provided on panel for easy field
configuration.
■ Generator Instrumentation and protection for all of the following; Volts, Hz, Amps, kW, kVA, kVAR, and PF.
■ Engine Instrumentation and protection for all of the following: RPM, Oil Pressure, Coolant Temperature, Battery
Voltage, Speed, Fuel Level, Engine Load and Speed detection via Generator Hz, MPU or ECU. Magnetic Pickups
available, but not included with panel.
■ Panel kit Includes: PROGRAMMED PANEL, Wiring schematics. Programming cable, 70 pin conversion harness.
Programming software available from www.basler.com
ORDERING
Part Number: P20 - D - X - EMCP3
X - 1=12 Vdc or 2=24Vdc
OPTIONAL MODULES
CEM-2020 Contact Expansion Module
AEM-2020 Analog Expansion Module
RDP-110 Remote Annunciator