Page 1 of 5939548205 Rev B

If you have a problem, question, or request, callyour local dealer, or Steelcase Line 1 at888.STEELCASE (888.783.3522)for immediate action by people who want to help you.(Outside the U.S.A., Canada, Mexico, Puerto Rico,and the U.S. Virgin Islands, call: 1.616.247.2500)Or visit our website: www.steelcase.com© 2007 Steelcase Inc.Grand Rapids, MI 49501U.S.A.Printed in U.S.A.

or a flat-bladedscrewdriver that is 8"

or longer

Torx T-20 & T30

482 Amia™ Chair - Arm or Arm Cap Replacement

Page 2 of 5939548205 Rev B

Arm Replacement

1. Locate the whitequick release tablocated on the lefthand side of the chair(as you sit in it)between the plates.

2. Lift the quickrelease tab (2a) whilelifting the seat slidelever (2b) and slidingthe seat forward & off.

2a

QUICK RELEASE TAB

FRONT REAR

FRONT

REAR1

2b

SEAT SLIDELEVER

Page 3 of 5939548205 Rev B

3. Remove two (2) screws on each arm.

4. Remove old arms.

5. Install new arms.

6. Install two (2) screws on each arm. Torque to 25-35 in/lbs.

3

4

4

6

5

5

6

SCREW

3

SCREW

Page 4 of 5939548205 Rev B

7. Align seat with chair control and engage slots on the bottom of the seat with the tabs located on the seat bearings (7a). Slide seat fully backwardwhile holding up on the seat slide lever (7b).

7a

TAB ON BEARING SLOT ON BOTTOMOF CHAIR

SEAT SLIDELEVER

7b

Page 5 of 5939548205 Rev B

1b1a

Arm Cap Replacement

1. To remove arm cap, remove four (4) screws (1a) and remove cap from arm (1b). To replace arm cap, reverse steps 1a and 1b and tighten screws to 6-10 in/lbs.

When installing, make sure to align the ribs on the two (2) screw bosses of the arm cap to the rear of the arm.

RIBS ON THESCREW BOSSES