Upload
others
View
5
Download
0
Embed Size (px)
Citation preview
Training on GTC
— Optimize the operation of your Gas Treatment Center — Enhance your plant efficiency and productivity — Reduce your OPEX costs — 2 levels available: first and advanced ones
A dedicated training program in accordance with your specific equipment
Aluminium
Copy
right
© 2
018
- Fi
ves
- Al
l rig
hts
rese
rved
.
CONTACT USE-mail: [email protected] Website: www.fivesgroup.com
Make sure your plant is always running at its highest level of performance
FIRST LEVEL classroom courses
— Process overview (GTC Process Flow Diagram and Process and Instrument Diagram review) — Dry-scrubbing modules (dust and HF treatment):• Filter bags• Bags cleaning system• Recirculated alumina system
— Alumina handling including distribution and storages (if applicable)
— Fans and blowers (exhaust fans, fluidisation blowers, airlift roots, booster fans, FCN fans)
— Gas cooling systems (induct sprayed process water, heat exchangers)
— Other equipment (bags leak detection, HF analysers, vacuum system)
Options if applicable:— Dual duct system (potline HF emission improved captation)— Force Convection Network (pot shell cooling system)— Wet scrubbers (SOx treatment)
On-site training— Daily routine inspection (performed by GTC operators,
focused on sensitive equipment)— Defect simulation— Control room (focused on GTC main critical parameters to
follow up)
Assessment test
THE RIGHT COMBINATION OF THEORY AND PRACTICE
ADVANCED LEVEL classroom courses
Process overview : — Dry-scrubbing modules (dust and HF treatment) — Fans and blowers — Gas cooling systems — Other equipment and options
Control System — Automation Hardware• Processor and redundancy• IO Control• Control networks• Level 2 Communication — Process and Instrumentation Diagram (PID) — Description of the PLC program philosophyexchangers)• PLC overall software program• Programming• Save/Restore of the PLC and Top Processor — Networking (control system architecture) — Calibration and configuration of field instrument• Digital instrumentation• Analogic instrumentation
Maintenance — Preventive and corrective maintenance — Continuous monitoring on control screens — Daily, weekly, monthly and annual inspections — Spare parts / Replacement — Calibration and balance
Audience• GTC operators and supervisors• English language training• 10 participants per session
Duration• First level: 2 days• Advanced level: 2,5 days
Results• Training material• Fives’ certificate
Take advantage of a team of experts always on the cutting edge of technologies