8/6/2019 Agricola Prospect

1/8

THE WINNING CHOICE...

AI-620MECHANICAL SEED DRILL AI-620FOR THE SEEDING OF VEGETABLES WITH MICROGRANULATOR

8/6/2019 Agricola Prospect

2/8

2

Mechanical seed drill AI-620 for the seeding of vegetables with microgranulatorFunctionality: Possibility to perform row or broadcast seeding of different types of seeds, from spinach beet to rocket salad,without changing the distributor.Distributors: The distributors may have 6 or 8 outlets.Speed gear: The machine is equipped with 2 speed gears with 80 + 80 ratios allowing performing changes in the productquantity that one wishes to spread.

RollersThe seed drill is equipped with 2 stainless steel seed rollers with 320 diameter. Upon request, it is possible to assemblerubber coated rollers (340 diameter). Advantages of rubber coated rollers: They are turned on the diameter; the rollerdoes not dent, if used on slightly rocky grounds and the earth does not stick to the roller in case of slightly wet grounds.

Adjustment of the seeding depth of the seeder blades

Thanks to a 4 crank adjustment system, it is possible to obtain a uniform adjustment of the seeding depth on both sides.The seed blades are oscillating, thus allowing avoiding more easily any hindrances. Moreover, it is possible to adjust theirpressure on the ground.

MicrogranulatorOur microgranulator can be configured with 2 boxes each with 3 outlets for a total of 6 outlets. Distribution of the productin front of the roller through broadcast seeding units.

8/6/2019 Agricola Prospect

3/8

3

Seeding distributorSeed distributor with foam horizontalroller. 6 or 8 outlets are available.

Distributor disassemblyThanks to this user-friendly distributordisassembly system, it is possible tounload the seed and perform thecleaning before introducing any newproduct.

Disassembly of the rollerDisassembly of the distributor roller toperform the cleaning of the roller in caseof product change.

8/6/2019 Agricola Prospect

4/8

4

ChangeChain speed gear with 80+80 ratios

F-30-26-22-18-14E-26-21-17-13

It is possible to change

D-30-26-20-13G-13-20-26-30

Side driveSide drive through which it is possible todouble 80 ratios changing the gearsfrom A-13 B-30 to A-16 B-22

20 change ratios

4 change ratios

2 change ratios

8/6/2019 Agricola Prospect

5/8

5

Seeder bladesThe seeder blades are tandemassembled and are not f ixed butoscillating, thus easing their adaptation

to the ground and simultaneously lettingpass any hindrance that may be present.Possibility of adjusting the seeder blades

through a spring to provide a greaterload to the ground.Possibility to shift the seeder blades bymeans of two screws to change thedistance between the rows.

Depth adjustment deviceDepth adjustment is carried out bymeans of 4 cranks of fering theopportunity to lift or lower the bladeseeder holding bar, thus assuring aperfect seeding depth.

8/6/2019 Agricola Prospect

6/8

6

Drive microgranulator No. 1Gearing of the microgranulator going from the 1st

shaft to the 2nd shaft.

Drive microgranulator No. 2Gearing of the microgranulator going from the 2nd

shaft to the microgranulator box.

Microgranulator outletsConfiguration with 6 broadcast seeding micro-granulator outlets.

MicrogranulatorConfiguration with 2 boxes with 3 outlets. Themicrogranulator box is equipped with a lever allowing

the adjustment of the quantity of product to bedistributed.

8/6/2019 Agricola Prospect

7/8

7

Drive between the two rollersGearing between the two rollers up to the 1 st shaft,where it is possible to mount the hydraulic motor and

the microgranulator drive.With this configuration, it is possible to mount both

the microgranulator and the hydraulic motor.When the microgranulator is mounted, it is suggested

to install the hydraulic motor, too.

Hydraulic motor roller drivePossibility to provide the machine with a 50CChydraulic motor, which conveys the motion to the frontroller.

Drive to the front rollerGearing from the front roller to the 1 st shaft, where itis possible to mount the hydraulic motor and themicrogranulator drive. Pre-arrangement for micro-granulator and hydraulic motor.

8/6/2019 Agricola Prospect

8/8

Via Artigianato, 9 - Zona Ind. - 35010 MASSANZAGO (PD) ItalyTel. (+39) 049.579.7533 - Fax (+39) 049.579.7756Web: www. agricola.it E-Mail: agricola@agricola.it

THE WINNING CHOICE...

www.d

itre.i

t

RollerStainless steel roller with 320 mm diameter and shaftwith 25 mm diameter.

RollerStainless steel roller covered with rubber and adjustedon 340 mm diameter and shaft with 25 mm diameter.