2
600 MW Coal-fired Electric Generating Unit FOR SALE This Unit 1 power block is a coal-fired electric generating unit comprising a nominal 600 MW GE steam turbine, tandem-compound 4-flow single reheat unit with throttle conditions of 3500 psig, 1050°F/1100°F. The Alstom steam generator is rated at approximately 4,650,000 lbs per hour capable of burning bituminous coal only or a combination of bituminous coal and petcoke (up to a 70%/30% blend). Coal pulverizers have significant design margin operating at ~70% for MCR firing. The plant design heat rate with this power block is 8725 BTU/kw-hr with tubine control valves wide open (VWO) and average ambient conditions in southeasern U.S. with a circular mechanical forced draft cooling tower, an electrostatic precipitatior, and a wet limestone flue gas desulphurization system. All cycle design has been incorporated into the equipment for sale and cycle information is available for all other normally desired conditions. Included with the block procurement of the equipment listed for sale is the design documentation of the power block. This includes all drawings, specifications, calculations, 3D modeling etc at the stage that currently exists. For sale separately are the continued services of the engineer of record for this design.

600 MW Coal-fired Electric Generating Unit turbine, tandem-compound 4-flow single reheat unit with throttle conditions of 3500 psig, 1050 F/1100 F. The Alstom steam generator is rated

  • Upload
    dinhdat

  • View
    214

  • Download
    2

Embed Size (px)

Citation preview

600 MW Coal-fired Electric Generating Unit

FOR SALE

This Unit 1 power block is a coal-fired electric generating unit comprising a nominal 600 MW GE

steam turbine, tandem-compound 4-flow single reheat unit with throttle conditions of 3500 psig,

1050°F/1100°F. The Alstom steam generator is rated at approximately 4,650,000 lbs per hour capable of

burning bituminous coal only or a combination of bituminous coal and petcoke (up to a 70%/30%

blend). Coal pulverizers have significant design margin operating at ~70% for MCR firing.

The plant design heat rate with this power block is 8725 BTU/kw-hr with tubine control valves

wide open (VWO) and average ambient conditions in southeasern U.S. with a circular mechanical forced

draft cooling tower, an electrostatic precipitatior, and a wet limestone flue gas desulphurization system.

All cycle design has been incorporated into the equipment for sale and cycle information is available for

all other normally desired conditions.

Included with the block procurement of the equipment listed for sale is the design documentation

of the power block. This includes all drawings, specifications, calculations, 3D modeling etc at the stage

that currently exists. For sale separately are the continued services of the engineer of record for this

design.

All design associated with the equipment listed is complete as are the foundations and buildings

for the boiler, coal silo bay, and turbine building, including all foundations which are of a heavy mat

design on piles that can easily transfer to other locations. The General Arangement of the power block is

fairly standard and completely developed for the critical piping, which is included in the equipment for

sale. Balance-of-plant equipment and facilities have all been specified and are ready for procurement.

The plant back-end design can be adjusted to match the buyers air emissions requirements and the fully

developed site layouts can be adjusted to meet the buyer’s site conditions. All P&ID’s are complete as is

preliminary piping and electrical physical design. A comprehensive PrimaVera level 3 schedule of

procurement, engineering, construction, and start-up is developed based upon the existing site

construction plan.

Offered by:

Cambridge Energy Waste Management, Ltd. 540 Frontage Road, Suite 3345, Northfield, Illinois 60093 USA

+1.847.784.0035 FAX +1.847.784.0038

For Information Contact Rudy Tagle