Embed Size (px)
Citation preview
DUDLEY
Pushbuttonsø73.5mm PNEUMATIC BUTTON
SINGLE AND DUAL FLUSHROYAL BUTTON SINGLE FLUSH
EXTENDED ROYAL BUTTONSINGLE FLUSH
DIO BUTTON - DUAL FLUSH
Collet
Nut
Button assembly
Surround
MINIFLO BUTTON - DUAL FLUSH
Collet
Nut
Button assembly
Surround
Nut
Button assembly
Nut
Button assembly
3/8” BSP Tubing
Pneumatic tube
1.1 Royal button
1.1.1 Mark position of button ensuring thereis no interference with cistern, support frame etc.
1.1.2 Cut hole.
40mm hole
1.1.3 Fit button assembly into panel andclamp in position with nut.
Move to section 2.
Washer
See section 1.1
See section 1.2
See section 1.3
See section 1.4
1.2.1 Mark position of button ensuring thereis no interference with cistern, support frame etc.
1.2.2 Cut counterbore and hole.
40mm hole x 25mm deep
Move to section 2.
1.2 Extended royal button
1.2.3 Fit assembly into wall.
1.2.4 Locate washer over tubing, attach nutand tighten until assembly is clamped inposition.
25mm hole
1 - Fitting -
See section 1.3
3mm -20mm
20mm -40mm
60mm - 290mm
325mm
75mm 75mm
SISLF323028 11294 Iss B
Collet
Nut
Button assembly
PIAZZA BUTTON SINGLE AND DUAL FLUSH
Collet
Nut
Button assembly
1.3.1 Mark position of button ensuring thereis no interference with cistern, support frame etc.
1.3.2 Cut hole.
40mm hole
1.3.3 Fit button assembly into panel andattach surround.
Move to section 2.
1.3 Dio and Miniflo button
1.3.4 Screw collet into nut. 1.3.5 Locate collet and nut assembly into the slots on the button assembly.
1.3.6 Tighten nut until assembly is clamped in position.
2 - Connecting pneumatic tubes -
3 - Operation -
2.1 Dual Flush - Cut pneumatic tubes to the minimum working length.Ensure tubes are not kinked or stretched.
Clear tube =full flush.
Green tube = partial flush.
3.1 Dual Flush - On reduced flush the large button will also travel when the small button is pressed. Allow time for cistern to fill before flushing.
Note - the buttons may return slowly after operation, this is quite normal.
Reduced flush
Full flush
2.2 Single flush - Cut pneumatic tube to the minimum working length.Ensure tube is not kinked or stretched.
1.4 ø73.5mm pneumatic button and Piazza button
Move to section 2.
1.4.1 Mark position of button ensuring thereis no interference with cistern, support frame etc.
1.4.2 Cut hole.
62mm hole
1.4.3 Screw collet into nut.
1.4.4 Fit button assembly into panel andlocate collet and nut assembly into the slotson the button assembly.
1.4.5 Tighten nut until assembly is clamped in position.
0mm - 50mm
50mm - 125mm
12mm - 32mm
105mm 170mm
114mm
Reduced flush
Full flush
Dauntless Works, P.O.Box 28, Birmingham New Road, Dudley,
West Midlands, DY1 4SN
Telephone: 0121 530 7000 Fax: 0121 557 5345
E-mail: [email protected]
