Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
CAE
Approach for principle polymer processing using measurements and simulation technologies
*
Keywords: Optical fiber, Injection molding, VaRTM. 1.
2. 1
1
FBI-Gauge1
J-650HPEC220N-16A 2
12
S2 S4 S1 S3T2
3 T3
Fig.1 Schematic illust. of Mold and Optical fibers
Fig.2 Strain and temperature change during molding
S1 S4 42 4
2
3 9PL 50
m
*Tadayoshi Takahara Nagoya Technical Center, Fuji Technical Research Ultimate Tower SakaeV11F, 5-28-18,Sakae, Naka-ku, Nagoya 460-0008, Tel: 052-269-1321, Fax: 052-269-1322 E-mail: [email protected]
11Copyright©2019 一般社団法人 プラスチック成形加工学会
特セ:射出成形・型内計測、更なる進化へ
A-101
Fig.7 Simulation accuracy
4S1
3D TIMON®
2
Fig.3 Comparison of measured and simulated strain
Fig.4 Comparison of measured mold strain and simulated resin pressure
3. 2 VaRTM
1
5
6
2 CoreTech
System Moldex-3D
Fig.5 Schematic illust. of Mold and Optical fiber
Fig.6 Flow front position for each carbon fiber lamination number
2)
4.
VaRTM
VaRTM
2
1) https://www.ftr.co.jp/solution/hardware/fbi_gauge/ 2) ’18,
103(2018)
12Copyright©2019 一般社団法人 プラスチック成形加工学会