Installation for Three Sided Enclosure #JG16E

For the enclosure to fit properly allow enclosure to come to room temperature before installing.

Fig.1

Place enclosure on top with pocket to the front. Hook pocket and pull enclosure to the rear, hooking rear corners tightly.

(Fig.1) Fold down three panels to allow sides to hang freely.

Fig.2

Unzip windshield frame sleeve from panel. (Fig.2)

Fig.3

Zip sleeve to windshield frame as shown. (Fig.3)

Fig.4

Zip four corners down and adjust enclosure to fit evenly. (Fig.4

Fig.5

Attach elastic anchors to the front and rear of running board.

Fig.6

Then mount windshield as shown.

Fig.7

Passenger exits enclosure as shown.

Fig.8

Enclosure should look as pictured when installed properly. The front pocket sleeve at the top can be tucked under out of

the way of windshield. During warmer weather enclosure sides can be unzipped, rolled up, and snapped under the

valance.