Make Switchable Privacy Glass Solution with Self-Adhesive Switchable Privacy Film

CNCCNCCNCCNC INTERLAYERINTERLAYERINTERLAYERINTERLAYER TECHNOLOGYTECHNOLOGYTECHNOLOGYTECHNOLOGYContactContactContactContact us:us:us:us: cnc@cncnext.comcnc@cncnext.comcnc@cncnext.comcnc@cncnext.com //// eva@evafilm.comeva@evafilm.comeva@evafilm.comeva@evafilm.com //// benext77@gmail.combenext77@gmail.combenext77@gmail.combenext77@gmail.com////benext77@hotmail.combenext77@hotmail.combenext77@hotmail.combenext77@hotmail.com

MakeMakeMakeMake SwitchableSwitchableSwitchableSwitchable SmartSmartSmartSmart GlassGlassGlassGlass SolutionSolutionSolutionSolution withwithwithwith Self-AdhesiveSelf-AdhesiveSelf-AdhesiveSelf-Adhesive

SwitchableSwitchableSwitchableSwitchable PrivacyPrivacyPrivacyPrivacy FilmFilmFilmFilmAboutAboutAboutAbout SFSFSFSF SmartSmartSmartSmart FFFFilmilmilmilm

Self-adhesive Smart Film is made of Protect Film, Adhesive Surface, ITO Film, Liquid Crystal &Polymer. It works same resemblance performances as the Privacy Glass made in laminating waywith NON-Adhesive Switchable Smart Film. Its very convenient and flexible to install theSELF-ADHESIVE Switchable Privacy Film on the ALREADY installed windows.

SELF-ADHESIVESELF-ADHESIVESELF-ADHESIVESELF-ADHESIVE SWITCHALBESWITCHALBESWITCHALBESWITCHALBE PRIVACYPRIVACYPRIVACYPRIVACYFILMFILMFILMFILM PerformancePerformancePerformancePerformance ParametersParametersParametersParameters+Switch on :Transparent+Switch off: Opaque+Dimmer: Transparent - opaque ( AC 0~110 V)+Power Consumption: SELF-ADHESIVE SWITCHALBE PRIVACY FILM has powerconsumption about 6~7W/m2+SELF-ADHESIVE SWITCHALBE PRIVACY FILM which is transparent or opaque, excludes99% outside UV Radiation.

Description Switch Data Description Switch Data

MilkyWhiteFilm

TransmittanceOn 87%

DarkGrayFilm

TramsmittanceOn 83%

Off 7% Off 7%

HazeOn 5%

HazeOn 2%

Off 78% Off 87%

Operate Voltage 90V AC

UV Blocked 99%

Adhesive Strength 0.01N/cm

StandardStandardStandardStandard SizeSizeSizeSize

ApplicationRatio ofW&L

Specification Dimension Width*Length

Display4/3

48 Inch 980mm*750mm64 Inch 1300mm*980mm

16/979 Inch 1600mm*1200mm96 Inch 2130mm*1200mm

Decoration andIndoor

980mm*3000mm

1200mm*3000mm

EquipmentEquipmentEquipmentEquipment RequiredRequiredRequiredRequired- Self adhesive Switchable Film- Window scraper / blade- Hard rubber roller- Soft edge squeegee- Nitrile protective gloves- LINT FREE Cleaning cloths- Liquid glass polish- IPA / Soft cloths- 1.5mm electrical cable- Cable strippers- Soldering iron / solder- Scissors / sharp blade- Dow Corning silicone (7091)- Plastic cover trim / clear double sided tape

PLEASEPLEASEPLEASEPLEASE NOTENOTENOTENOTE- The External dimensions of the SELF-ADHESIVE Switchable Privacy Film are 2 - 3mm smallerthan the visual area of the windows.- The BUS-BAR (electrical contact strip) should never contact with any metal frame or trim.

STEPSTEPSTEPSTEP 1111

Place the SELF-ADHESIVE Switchable Privacy Film in a safe clean table.STEPSTEPSTEPSTEP 2222

Make sure the CLING surface is facing up.STEPSTEPSTEPSTEP 3333

Spray the glass with LIQUID glass polish and use a window scraper or blade to remove any dirt orblemishes from the glass surface.STEPSTEPSTEPSTEP 4444

Spray the glass with LIQUID glass polish and clean with a SOFT LINT-FREE cloth.Then Using a LINT FREE cloth, wipe the glass surface with IPA (Isopropyl Alcohol) and wait forEVAPORATE.STEPSTEPSTEPSTEP 5555

Wipe down the Protective Liner on the cling side of the SELF-ADHESIVE Switchable PrivacyFilm to remove any dust.STEPSTEPSTEPSTEP 6666

Remove the first 100mm (4”) of the protective liner covering the cling side onthe BUS-BAR edge.Make sure that you do this in a clean dust free environment.

Remove the Protective Liner from the ADHESIVE STRIP on the BUS-BAR edge.

Make the BUS-BAR edge of the SELF-ADHESIVE Switchable Privacy Film along with the topedge of the glass. When in position, run your finger along the BUS-BAR to fix the top edge.

Gradually pull away the protective liner and allow the film to slowly adhere to the glass surfaceunder its own pressure.Using the roller move down the film working in horizontal lines left to right to disperse any airbubbles.If any small bubbles are visible, carefully lift the film and let it sit back down under its ownpressure again until you have a bubble-free installation.STEPSTEPSTEPSTEP 11110000

Use the soft edge squeegee to work any small bubbles and the edges of the film.But if any edges are lifting slightly, do not worry, they will relax down once the PROTECTIVELINER is removed.STEPSTEPSTEPSTEP 11111111

Once the film is installed on the glass you can then start work on wiring the bus-bar. Carefullysolder the electrical cable to the mesh tags.There are two tags on the left hand side and two tags onthe right hand side. Solder a cable to one tag on the left (positive connection) and one tag on theright (negative connection). The other tags are only there as spares. You can use them to connectthe cables to a switch or transformer and test the switching from frosted to clear. Once you havetested successfully, you can trim off the spare mesh tags.STEPSTEPSTEPSTEP 11112222

Now you can carefully remove the other protective liner.STEPSTEPSTEPSTEP 11113333

Run some clear double-sided tape along the bus-bar edge to hold your electrical cables in placewhile you prepare the cover trim.STEPSTEPSTEPSTEP 11114444

Use Dow Corning (7091) non-acid based silicone along the bus-bar edge to hold the protectivecover trim in place. We recommend you use a plastic cover trim.STEPSTEPSTEPSTEP 11116666

Now, Congratulations! The installation is complete and you can clean the film. For mostinstallations we would recommend that you use a cover trim on all edges of the film.

Implication Example:

Make Switchable Privacy Glass Solution with Self-Adhesive Switchable Privacy Film

Technology

SWITCHABLE SWITCHING REGULATOR CONTROLLER …

Light‐Switchable Azobenzene‐Containing Macromolecules

SWITCHABLE LANTHANIDE FLUORESCENCE PROBES IN …

Designing Switchable-Hydrophilicity Solvents and Modelling

Washable Glass Film for privacy and UV protection… · vinyl film • Easy to remove For safety, total privacy or a complete new look, try quality NewDecor UV reducing self adhesive

Switchable smart section blind

Apply smart switchable privacy film to the installedwindows

Switchable Lumen Panel - Acuity Brands

Boubyan National Medical Company · 2020. 2. 20. · health-care ideal solution for healthcare environments switchable electric glass offers the advantage of improved patient privacy

Towards redox-switchable organocatalysts based on

Materials with switchable radiometric properties: Could

Smart switchable glass project

Magnetic Adsorbents Displaying Switchable Ion-Exchange

Make Switchable Privacy Glass Solution with NON-ADHESIVE Privacy FILM In Laminating Method

ALL TOOlS YOU NEED FOR INSTALLING SELF-ADHESIVE PRIVACY SMART GLASS FILM FOR INSTALLED WINDOWS

Switchable Synthesis of Z-Homoallylic Boronates …eprints.nottingham.ac.uk/51268/1/Hon Lam Switchable...temperature-controlled, switchable synthesis of allylic and homoallylic boronates

Redox-switchable siderophore anchor enables reversible ...eprints.whiterose.ac.uk/133036/15/Redox_reversible_anchor_SI.pdf · Redox-switchable Siderophore Anchor Enables Reversible

Secret 4-Way for DELL Latitude 5289, self-adhesive · Secret 4-Way for DELL Latitude 5289, self-adhesive The Secret 4-Way privacy filters prevent your display from being viewed from

Switchable privacy glass catalogue | Dream Glass Group

Curved Switchable Privacy Glass Solutions · CURVED SWITCHABLE PRIVACY GLASS is an electrical laminated glass product. The film interlayers we use are PDLC and PVB and these components