View
344
Download
1
Category
Preview:
Citation preview
TEH-C100TEH-C400TEH-C410TEH-C700TEH-C900TEH-C800TEH-C810
TEH-C100 TEH-C400TEH-C410 TEH-C700TEH-C900 TEH-C800TEH-C810INSTRUCTION MANUAL
TEH
TEH
After the instrument is electrified mormally,M will enter and finddata lock parameter"LCK"according to Parameter setting mode,andset "1000"as code then press"SET"dey to confirm,press two keys("SET"key and "<"key)simultan eously About three seconds later,thePV display will show"Cod"When "Cod"equals to "000",press"set"keyin turn,then can get and display the following parameter in a cyclye.
The Setting of Instrument Parameter Mode
Showing sign instructionthe setting value
omitomitNot set the first alarm function the style choice of the first alarmUpper limit deviation alarmUpper/lower limit deviation alarmProcess value u pp er limit deviation alarmLower limit deviation alarmHave alarm(alarm in the scale)Process value lower limit deviation alarmHaven't idle alarm function The idle function choice of the first alarmHave idle alarm functionTh e setting of th e second alarm fu nction the same as the abovePosit iv e m ovem ent con trolling(cooling) main c ontrol ling po sitive/negative mov ement choiceNegative movemen t controlling(heat in g)Main controllin g t ime proportion output the style choice of main controlling outputMa in co ntrol lin g in p ro gress io n ou tpu t(4-2 0 m A)Encouraging alarmNot encouraging alarmEncouraging alarmNot encouraging alarmomitomitomitomit
Encouraging alarm/ not encouraging alarm (the first alarm )
Encouraging alar m/notencouraging alarm(the second alarm)
Showing sign instructionleaving factory value
a c co rding to th e orde ra cc ording to th e orde r
the setting rangeth e mea su rin g ra ng e u pp er l imit o f se tt ing v a lu eAthe measuring range lower limit of setting valuethe digit of radix pointAT self adjustment output bandwidthThe first alarm output no action bandwidththe second alarm output no act ion bandw idthnumberal filtering constant
see the above formsee the above form
ororor
ororor
When "Cod"equals to "0001",press"set"key in turn,then can get anddisplay the following parameter in a cyclye.
Recommended